MAN00000772_SI-G200BB_SVCPDFA.pdf - 第679页

Chan ge Pro cedu re for Ro tary En co der [ Re assem b l y] 9 Attach the Enc oder Le af S pring to the New e nco der with scre ws (3-C3x 3, 3-W3) . 10 Attach the enco der to the ax is without stress to the c able, and te…

100%1 / 712
Change Procedure for Rotary Encoder
6
Remove the screws (3-C3x3, 3-W3), and remove
the Encoder Leaf Spring.
7 Loosen the screws (C2.5x8), and remove the Set Collar.
8 Pull out and detach the encoder.
Change Procedure for Rotary
Encoder
RPGB-10701-1
SEET
3/5
Set Collar
C2.5x8
C3x3,W3
Change Procedure for Rotary Encoder
[Reassembly]
9 Attach the Encoder Leaf Spring to the
New encoder with screws (3-C3x3, 3-W3).
10
Attach the encoder to the axis without stress to
the cable, and temporarily attach the set collar.
POINT
Insert it carefully in the direction of the Set collar.
The flat side should be attached on the upper side.
11
Adjust the position of RT axis and Z phase of the encoder.
1. Rotate the RT axis, adjust the No.2 shaft position to the
under the RT ORG sensor.
2.Adjust the Z phase position (marking-off line) of the encoder.
12 Adjust the gap between encoder and nut.
(measured by item 5)
Confirm the item 11 again.
Tighten the screw (C2.5x8), fix the encoder by set collar.
Change Procedure for Rotary
Encoder
RPGB-10701-1
SEET
4 /5
Cable Position
Installation
Position
C3
x
3
W3
Set Collar
C2.5×8
C3x3,W3
Encoder Leaf Spring
RT Dog
RT ORG Sensor
1
8
7
6
5
4
3
2
Change Procedure for Rotary Encoder
13 Attach the encoder bearing holder.
1. Attach the bearing and the spacer to
the encoder bearing holder.
2. Attach the completed assy holder by pushing slowly.
3. Apply the adhesive (Locktite601) to the inner of spacer.
4. Tighten the screws (4-C3x8).
14 Tighten the screws (3-C3x4, 3-W3) to lock
the encoder bearing holder.
15 Tighten the screws (2-B3x16), and attach the manifold.
16 Install the head unit. Refer to RPGB-10301-1
[Adjustment]
17 Calibration
1.HLGB-10202-01 Machine Setup
2.HLGB-10303-01 Calibration
Change Procedure for Rotary
Encoder
RPGB-10701-1
SEET
5 /5
Bearing
Encoder Bearing Holder
Spacer
Locktite
601
Completed Assy Holder
Locktite 601
C3x8
W3
CP3x4
Leaf
Spring
B3x16
Encoder
Bearing Holder
Manifold