MAN00000772_SI-G200BB_SVCPDFA.pdf - 第700页

XY axis movable parts RPGB-1 1201-01 Change Proce dure for X Axi s LM-GUIDE SEET 5 / 7 7, Cleaning of the slide block and installation surface 8, Match a slide block with the installation side of the X-axis Base Saddle, …

100%1 / 712
XY axis movable parts
RPGB-11201-01
Change Procedure for
X Axis
LM-GUIDE
SEET
4/7
3, Set LM-guide hold jig
POINT
Presses side is seen at back.
Position order start is from left-hand side
І , П , (Ш···)
4, Tighten of tension screw (M4) for
press to L M-guide and base
After tighten of LM-guide fixed screw
M4 tension screw Tightening torque 50 (cN.m)
LM-guide screw Tightening torque 206(cN.m)
POINT
Presses side is seen at back.
Position order start is from left-hand side
1,2,3,(4···)
5, JIG moves to the next position
Please repeat 3.4 works
6, Confirm the gap between base level and LM-guide
POINT
Thickness gauge0.02mm do not enter
JIG
Left side
1
2
3
4
・
・
・
M4　Tension　screw
Ⅰ
Ⅱ
Ⅲ
XY axis movable parts
RPGB-11201-01
Change Procedure for
X Axis
LM-GUIDE
SEET
5/7
7, Cleaning of the slide block and installation surface
8, Match a slide block with the installation side of
the X-axis Base Saddle, Temporarily stop the screw
(LM-guide of Basis side and Subordinate side)
9, Press to slide block and installation surface of
the X-axis Base Saddle Then tighten it
(Basis side LM-guide)
Confirm the gap between base level and LM-guide
POINT
Thickness gauge0.02mm do not enter
M/C
OUT SIDE
M/C
IN SIDE
XY axis movable parts
RPGB-11201-01
Change Procedure for
X Axis
LM-GUIDE
SEET
6/7
10, Slide block and installation surface of
the X-axis Base Saddle tighten it
(Subordinate side LM-guide)
POINT
Confirm Motion smoothly when move
X-axis back and forth
11, Confirm the position of X axis Base Saddle,
2 – 3mm from the motor side of mechanical end
Then Install ball screw of nut folder to
the X-axis Base Saddle, tighten it
11-1 Push a nut holder to a positioning pin
and tighten a screw at the opposite angle
11-2 Loosen a screw fixing a nut holder and the nut
of the ball screw and close it at the opposite angle again
11-3 again 12-1
11-4 again 12-2
POINT
Confirm Motion smoothly when move
X-axis back and forth