00193891-0702_AI_LP_Barcode_DE+EN.pdf - 第185页
SIPLACE 2 PCB barcode scanner assembly instructions 10/2009 Edition 2.7 Installing the PCB barcode scanner 185 : Fasten the supp orting brackets for the bo ttom cross-ra il. : Place the ba rcode scanner(s) in positio n. …
2 PCB barcode scanner assembly instructions SIPLACE
2.7 Installing the PCB barcode scanner 10/2009 Edition
184
: Pull the extension kit gently outwards and thread the cover switch cable through between the
machine and the extension kit (see photo).
2
2
: Place the lower transverse rail in the extension kit.
: Screw the three screws up again.
: Screw the new s
idewalls into the PCB feeder with four screws (5 x 8).
4 screws
2
2
: Screw the cover switch on loosely.
The screw belongs in the through hole, not the slot.
SIPLACE 2 PCB barcode scanner assembly instructions
10/2009 Edition 2.7 Installing the PCB barcode scanner
185
: Fasten the supporting brackets for the bottom cross-rail.
: Place the ba
rcode scanner(s) in position.
: Insert the bottom c
ross-rail.
Adjust the position in the slot.
2
2
: Fit the top supporting bracket.
The screws go into the slots on the left as the cover switch has to be fastened to the left side
of the feed
er as well as the bracket.
Screws in left
slots
2
2
: Fit the top cross-rail. Adjust the position in the slot.
2
2 PCB barcode scanner assembly instructions SIPLACE
2.7 Installing the PCB barcode scanner 10/2009 Edition
186
: Fasten the scanner(s) to the cross-rails with the knurled screws (see photo below).
To read barcodes that are printed lengthwise on the PCB (
viewed in the PCB direction of travel),
the barcode scanner can also be installed lengthwise (1D barcode scanners only). 2
: Lay the barcode scanner cables with the cable clips on the cross-rail.
Cable clips
Topside and underside scanners (1D) mounted crossways
Topside and underside scanners (1D) mounted longways
Knurled screws
2
2
2