00193891-0702_AI_LP_Barcode_DE+EN.pdf - 第239页

SIPLACE 2 PCB barcode scanner assembly instructions 10/2009 Edition 2.11 PCB barcode scanner configuration 239 : Click on the "Prepare AutoSetup" button. The velocity and module size are se nt to the barcode sc…

2 PCB barcode scanner assembly instructions SIPLACE

2.11 PCB barcode scanner configuration 10/2009 Edition

238

Fig. 2.11 - 30 Focus height set correctly

: Click on "Next".

2.11.7.7 DataMatrix AutoSetup for automatically teaching a 2D barcode:

FTP program button

The FTP program is

used to record im-

ages of unscanned

barcodes, for exam-

ple, and analyze the

errors during start-up

or production

(See Requesting im-

ages during produc-

tion).

Fig. 2.11 - 31 Step 5 in the CLV Assistant

: Enter the conveyor velocity and the size of a matrix dot (module size).

SIPLACE 2 PCB barcode scanner assembly instructions

10/2009 Edition 2.11 PCB barcode scanner configuration

239

: Click on the "Prepare AutoSetup" button.

The velocity and module size are sent to the barcode scanner.

The "Snap an image" button is now active.

Requirements for snapping the image:

– The machine with the barcode scanner to be configured must be "Waiting for PCB".

– Press the STOP button on the upstream machine.

– Place a PCB with the barcode on the output belt of th

e up

stream machine so that the bar-

code is approximately 1 cm in front of the scanning beam.

: Click on the "Snap an image" button.

: Then press the START button on the upstream machine.

: The "Start Autosetup" butto

n should now be active.

Fig. 2.11 - 32 Step 5 in the CLV Assistant

: Click on the "Start Autosetup" button.

If the barcode is read successfully, the data for the con

veyor velocity, module size and optimization

parameters such as contrast, brightness, etc. are determined.

PLEASE NOTE:

These parameters should not be manually changed again.

2 PCB barcode scanner assembly instructions SIPLACE

2.11 PCB barcode scanner configuration 10/2009 Edition

240

Fig. 2.11 - 33 Result window on the right showing the barcode data

Fig. 2.11 - 34 Step 6 in the CLV Assistant

The settings found by the CLV Assistant only apply to this type of barcode.

: Click on "Next". This closes the CLV Assistant.