80S-15贴片机.pdf - 第143页

SIPLACE 80 S/ F/G Service M anual 6 PCB Handling Edition 01/96 6 - 7 6.2 Geared Motors of th e PCB Trans portation Syste ms 6.2.1 Replacing the input an d center co nveyor gear ed motors Spare parts, auxiliary materi als…

100%1 / 484
6 PCB Handling SIPLACE 80 S/F/G Service Manual
Edition 01/96
6 - 6
Fig. 6.1.2 Lifting table and width adjustment
1
12
3
4
6
7
5
8
9
10
12
13
14
15
16
17
18
19
20
21
22
4
A
2
11
SIPLACE 80 S/F/G Service Manual 6 PCB Handling
Edition 01/96
6 - 7
6.2 Geared Motors of the
PCB Transportation Systems
6.2.1 Replacing the input and center conveyor geared motors
Spare parts, auxiliary materials and equipment
Geared motor with synchronizing disk, Item No. 00324405-01
SITEST program
6.2.1.1 Removing the geared motor from the input and output conveyors
NOTE
OOO
You should also comply with the safety instructions given in Chapter 1.
●
Select the maximum width setting for the board conveyor so that you can carry out servicing work unim-
peded.
●
Move the gantry or gantries to outside the board transportation area.
●
Switch off the machine at the main switch and disconnect it from the main power supply.
●
Make sure that the machine cannot be switched on while you are carrying out servicing work.
●
Mark the installed position of the geared motor and also label the cable connections as protection against
incorrect polarity upon reinstallation.
●
Remove the cable shoes from the motor terminals.
●
From the conveyor motor strip the heat-shrinkable sleeves which fasten the connecting cable.
●
Unscrew and remove the 4 mounting screws (4 M3 slotted head screws) of the geared motor (A).
●
Tilt the geared motor a little to one side while carefully pulling the geared motor backwards and out (B).
Make sure that the synchronizing disk does not catch in the toothed belt.
6 PCB Handling SIPLACE 80 S/F/G Service Manual
Edition 01/96
6 - 8
Fig. 6.2.1 Removing the geared motor of the input or center conveyor
Key to Fig. 6.2.1
1 Input conveyor 2 Center conveyor
3 Output conveyor 4 Geared motor
5 Input conveyor motor mount 6 Center conveyor motor mount
3
1
2
4
4
5
6
B
A
A
B