WinMCS_Manual(ENG) rev1.0.pdf - 第21页
21 Service Manual Koh Y oung T echnology Inc. 4. SETTINGS PARA M S It is able to check the setup state of W inMCS and to change it. Location: Menu Settings Syst e mSettings Gener al 4.1. GENER A L SETTING It shows …
20
WinMCS_Manual(ENG) rev1.0
Koh Young Technology Inc.
3.6. Laser Mode
N
N
o
o
t
t
e
e
For more information about Laser mode, see Laser Setting Manual.
21
Service Manual
Koh Young Technology Inc.
4. SETTINGS PARAMS
It is able to check the setup state of WinMCS and to change it.
Location: Menu Settings SystemSettings General
4.1. GENERAL SETTING
It shows all the settings with regard to motion control of machine, the setting should be
matched correctly with the type of machine. More details will be covered below.
4.1.1. GENERAL SETTING
22
WinMCS_Manual(ENG) rev1.0
Koh Young Technology Inc.
TYPE
It is the settings related to Machine Type, Motion Board Type, and I/O Board Type.
1. Machine Type
Select the machine type in use.
2. Motion Board Type
Select the type of motion board in use on machine.
3. I/O Board Type
Select the type of I/O board in use on machine
0. Acromag– Obsolete
1. Emotion– Select if there is a PCI slot in Vision PC
2. MCBEmotion– Select if I/O Module Pack is installed on machine
3. EmotionEctension– Select if both Emotion and MCBEmotion board are used
4. Encoder Type
It is for the setting of motion control used in X and Y gantry.