WinMCS_Manual(ENG) rev1.0.pdf - 第29页

29 Service Manual Koh Y oung T echnology Inc.  AXIS STROK E(U nit. mm ) 1. Set up the MIN/MAX motion range in X, Y , a nd Z axis. (V alues di ff er from the machine t ype) It serves a n i nterlock function in S /W , and…

WinMCS_Manual(ENG) rev1.0

Koh Young Technology Inc.

 PCB ORIGIN

The reference point of inspection. As below picture, if PCB flow direction is from Left to

Right side, the bottom left side is the origin of PCB, and If PCB flow direction is from Right

to Left, the bottom right side is the origin of PCB

Service Manual

Koh Young Technology Inc.

 AXIS STROKE(Unit. mm)

1. Set up the MIN/MAX motion range in X, Y, and Z axis. (Values differ from the machine type)

It serves an interlock function in S/W, and the movement command has to be set within this

range.

2. When you set AXIS STROKE, the range has to be set within the position of +, - Limit Sensor.

 FID_INSPECTION_METHOD

It is the order of fiducial mark inspection on array board.

0. Fid->Pad->Fid->Pad->…: Inspect the fiducial marks and start pad inspection on each array.

1. Fid All -> Pad All Inspection: After inspecting all fiducial marks in the board, pads are

inspected.

WinMCS_Manual(ENG) rev1.0

Koh Young Technology Inc.

 Machine Origin Offset

This is to use full stroke of each axis. When the probe moves to (-)Limit of X axis, (+)Limit

of Y axis as following picture, the center of Z axis(probe) is not completely matched to the

Limit due to the nature of machine. The offsets, which occur here, are compensated in this

option. (Factory Setting)

 CONVEYOR WIDTH

When the rail width is adjusted, the limit of MIN/MAX rail width can be set here in this

item. If the values are not within min-max range when the conveyor width is adjusted,

errors occur.