WinMCS_Manual(ENG) rev1.0.pdf - 第54页

54 WinMCS_Manua l(ENG) rev 1.0 Koh Y oung T echnology Inc. 4.7. MUL TI FIDUCI AL INSPECTI ON It is setting fo r Multi Fiducial . Location: Menu  Settings  Syste mSettings  MULTIFID 4.7.1. MUL TI FID It is to set a fun…

Service Manual

Koh Young Technology Inc.

2. SetBack 1 Outlet Option :

0. DON’T USE: Do not use SetBack 1 Outlet Mode.

1. OUTLET_PASS: After inspecting PCB when it arrives at the work position from Entry,

the request signal would come from the previous machine. Then, pass it to the previous

machine.

PCB PCB

[Figure 1. Inspection] [Figure 2. Pass the PCB after inspection]

2. ENTRY STOP: After inspecting PCB as below picture, PCB is stopped at the entry

position. The user has to remove the PCB at this moment and load it again at the entry

position. Then, repeat it.

PCB PCB

PCB

[Figure 1. Inspection] [Figure 2. Stop at the entry after inspection]

3. Belt LD Option: PCB Loading Option

Entry Sensor:

When Entry In Sensor detects a PCB, conveyor belt moves.

Entry & Smema:

When the Smema Ready signals of both Entry In and previous machine are on, conveyor

belt moves.

 Max Warpage Limit Setting

It is to set the warpage limit. If the warpage larger than the set value occurs when Z-

Tracking Inspection, it is judged error.

WinMCS_Manual(ENG) rev1.0

Koh Young Technology Inc.

4.7. MULTI FIDUCIAL INSPECTION

It is setting for Multi Fiducial.

Location: Menu  Settings  SystemSettings  MULTIFID

4.7.1. MULTI FID

It is to set a function to inspect using Multi Fiducial.

Service Manual

Koh Young Technology Inc.

 ScaleFactor Setting

1. Origin ScaleFactor (Zoom 1 Position)

Input the machine ScaleFactor values which are set in GUI.

2. Zoom 2 Scalefactor

If Step Zoom option is used, input Zoom2 Position Scalefactor values.

If Step Zoom option is not used, no need to input this column.

3. Zoom 3 Scalefactor

If Step Zoom option is used, input Zoom3 Position Scalefactor values.

If Step Zoom option is not used, no need to input this column.

 2 Fiducial Auto Scale per Board

1. 2 FID MULTI INSP

0. Don’t Use: 2 Fiducial Auto Scale per Board is not used.

1. Default (Use): Using 2 fiducial marks to inspect scale.

2. 1 Fid (Use): Using 1 fiducial mark to inspect scale.