WinMCS_Manual(ENG) rev1.0.pdf - 第39页
39 Service Manual Koh Y oung T echnology Inc. 2. SMEMA T ime Delay It is to set p rev ious Smema signal o ff time and ne xt Smema signal off time. Printing Cle ani ng This is a functio n which is co nnected with pri nt…
38
WinMCS_Manual(ENG) rev1.0
Koh Young Technology Inc.
NG Sig. Type
It is to set when NG signal should be terminated.
0. When PCB Out:
It is used for the type of Buffer that Kohyoung machine received NG signal and then send
Request Signal, When PCB is sent out from Kohyoung machine, NG signal is terminated.
1. When PCB nSmemain off:
It is used for the type of Buffer that Request signal is sent and then receive NG signal.
When Request signal (Next in Signal) is off, NG Signal is off as well.
2. When Next PCB Out:
NG signal is kept until the next PCB is coming to the entry of machine.
SMEMA Option
1. SMEMA Option
0. PCB Ready -> ON:
After inspection is finished, ready signal is sent to next machine and receive Request signal
from next machine. Then, Stopper would go up, and conveyor belt would start running to
send the PCB out of machine. The time between Stopper Up and Belt running is defined
by “Stopper and Belt Delay” item in Inspection Ready time delay option.
1. PCB Send -> ON:
After inspection is finished, receive only Request signal from next machine. Then, Stopper
would go up, and conveyor belt would start running to send the PCB out of machine. The
time between Stopper Up and Belt running is defined by “Stopper and Belt Delay” item in
Inspection Ready time delay option.
39
Service Manual
Koh Young Technology Inc.
2. SMEMA Time Delay
It is to set previous Smema signal off time and next Smema signal off time.
Printing Cleaning
This is a function which is connected with printer, and it performs printer cleaning(GUI
setting interworking) if error occurs consistently in a same pad. (Applicable printer:
Hitachi)
1. NG Signal Option
0. UNUSE: It is not to use printer cleaning
1. USE: It is to use printer cleaning
2. PORT NUMBER
It is to set the Output Number to connect printer.
3. Sig Time
It is to set the Toggle Time of Printer Clean Signal. (On/Off Time setting)
40
WinMCS_Manual(ENG) rev1.0
Koh Young Technology Inc.
Work out Position
Set the position of X, Y Motion when Work Out button is pressed.