00197394-03_AI_Smart-Pin-Support_X-S_DE_EN.pdf - 第119页
5 Annex 5.1 Magazine Recognition Circuit Diagram Assembly Instructions / Montageanleitung SIPLACE X-Series S Smart Pin Support 05/2019 119 5 Annex 5.1 Magazine Recognition Circuit Diagram Fig.55: Magazine Recognition Ci…
4 Maintenance
4.2 Maintenance Tasks Smart Pin Support - Major
118 Assembly Instructions / Montageanleitung SIPLACE X-Series S Smart Pin Support 05/2019
4.2 Maintenance Tasks Smart Pin Support - Major
4.2.1 Maintenance Intervals
Maintenance tasks
Smart Pin Support
Duration [min] Each
week
Every 3
months
Every 6
months
Every 12
months
Cleaning the interface 2 X
Cleaning the pins 3 (per 5pieces) X
4.2.2 Tools, Consumables, Spare and Wear Parts
●
Lint-free cloths [03082092-xx]
●
Cotton wool buds [00352931-xx]
●
SIPLACE cleansing tissue [00315253-xx]
●
Ethanol
Isopropanol – IPA can be used as an alternative.
4.2.3 Preparatory Steps
► Move all component trolleys out of the machine.
► Switch off the machine and secure it to prevent unauthorized reactivation. Observe the
instructions in section 1.2 "Preparatory work..." [}75].
4.2.4 Performing Maintenance Tasks
4.2.4.1 Clean the interface at the Pin-Picker
Fig.53: Cleaning the interface
► Move the gantry into Y direction until the
mechanical stop in order to have a good
access to the pin picker.
► Wet a cottonwool bud with ethanol.
► Clean the ball grid inside the interface (1)
using a cottonwool bud.
► Lead the cottonwool bud to the end of
the interface. Clean the centering plate
there.
► Repeat these steps for all pin pickers.
4.2.4.2 Cleaning the Pins
Fig.54: Cleaning the pins
► Clean the pin surface and the pin
grooves (1) using a SIPLACE cleaning
cloth.
► Remove redundant oil from the magnet
foot(3) and the contact area(2) at the
magnet foot with a dry lint-free cloth.
► Repeat these steps for all pins.
5 Annex
5.1 Magazine Recognition Circuit Diagram
Assembly Instructions / Montageanleitung SIPLACE X-Series S Smart Pin Support 05/2019 119
5 Annex
5.1 Magazine Recognition Circuit Diagram
Fig.55: Magazine Recognition Circuit Diagram
5 Annex
5.2 Magazine recognition board
120 Assembly Instructions / Montageanleitung SIPLACE X-Series S Smart Pin Support 05/2019
5.2 Magazine recognition board
Fig.56: Magazine recognition board [03093494-xx]
The magazine recognition board is part of the
pin magazines for the "Smart Pin Support" op-
tion.
This board may be missing, depending on the
magazine version used.
LEDs:
H3: not used
H4: FPGA OK
H6: Power supply 3.3 V OK
DIP switch S1 - jumper assignment
S1.1 S1.2 Magazine connected at:
ON OFF NC connection 2
OFF ON NC connection 4
S1.4 S1.5 S1.6 Meaning
OFF OFF OFF Garage is switched off
ON OFF OFF Garage type W5
OFF ON OFF Garage type Q10
ON ON OFF Garage type L10
X X ON Reserved
NOTICE
Jumper S1.3 is not used.