c900795.R02_EN.pdf - 第26页

1 Installation 1-12 NOTE: The hydraulic jacks must satisfy the following requirem ents. Allowable load: 1.5 tons or hi gher Hook size: 100mm or more (stroke) Part Name Part No. Remark PLATE,BASE LG0-M8911-00X For plates …

1 Installation

1-11

Supplementary Explanation for Installation

When setting up a production line, level adjustment and line positioning of the unit may be carried out at the

same time. However, to fine-adjust the unit position with the unit level, it is recommended that the unit be

roughly positioned to the production line first, and then be leveled and positioned accurately using the

following four sets comprising a hydraulic jack and plates.

ACTION:

① Apply grease between base plates 1 and 2 for lubrication purposes.

② Place a plate set near each unit jack-up point (four points).

③ Place a jack on each plate set and jack up the unit.

④ Adjust each jack so that the unit is level.

⑤ Fine-adjust the position of the unit while the unit is jacked up. (The unit can be moved lengthwise and

crosswise with help of grease applied between the plates.)

Hydraulic jack

Base plate 1

Base plate 2

Apply grease

between the

lates.

Hook stroke

1 Installation

1-12

NOTE: The hydraulic jacks must satisfy the following requirements.

Allowable load: 1.5 tons or higher

Hook size: 100mm or more (stroke)

Part Name

Part No. Remark

PLATE,BASE LG0-M8911-00X For plates 1 and 2

Jack -Up Points

Two Positions each at machine front and rear sides

D10 base

1 Installation

1-13

Removal of Rust Inhibiting Grease

At packing and shipping, a large amount of grease is applied on the surface of each ball-screw and linear

guides on X/Y axes in order to prevent rust. As each axis moves an excess grease is gradually removed

from their surface and a proper amount of grease remains as a lubricant.

For this reason, when these axes are moved at installation, the extra grease may be built up on ball-screw

nuts, on linear guide sliders, and both ends of each axis. If you run the unit at high speed (production)

without wiping it away, the grease may be scattered around due to centrifugal force and vibration, and that

may stick to cameras, sensors, or a board.

Please perform a warm-up at low speed once the origin is acquired after installation, and wipe off any

excess grease as necessary.

The unit may not function properly when grease sticks to the sensors and the

cameras.

ACTION:

① Check and remove any board and tools from inside of the unit, and then perform origin acquisition.

② Select Main Menu> Manual> Warm Up.

③ Select Warm-up & Self-diagnostics> Setting.

④ Select [XY-axes] and set up the parameters as follows.

1: Check “Execute Warm-up of XY-axes”.

2: Set “Axis Speed” at 10%.

3: Check “XY “.in Axis.

4: Check “Entire Area Check“in Range.

* It is not necessary to check other items.

３

１

２

４