00193407-02 HWWS SIPLACE Machine Accuracy EN.pdf - 第122页

. Seite 22 © Siemens AG . . Änderungen vorbehalten SIPLACE Placement Systems ¾ mount the star in the marked position. To do so, pu ll out the 3 segments , located below the fastening tools. ¾ put the star carefully ba ck…

. Seite 21

SIPLACE

Placement Systems

order number 00326164-01

don’t mix it up with the gauge for adjusting the zero point correction

gauge star axis

C&P DLM head: z-axis gauge shown below must be used

see Technical Info 10C06014

Attention: only for C&P DLM head

Assembly Z-Axis only DLM Head

0,15mm

0,05mm

. Seite 22

SIPLACE

Placement Systems

¾ mount the star in the marked position. To do so, pull out the 3 segments, located below the

fastening tools.

¾ put the star carefully back onto the motor shaft.

ATTENTION:

don’t squeeze the vacuum tubes and ensure the segment bearings run

correctly in the raceway.

¾ insert the 3 screws (DIN 912 M3x8mm) for the star, do not tight them yet.

¾ mount the star zero point correction tool.

Continuing all C&P head M 8000 / M10000, DLM head

Assembly Z-Axis (continuing)

. Seite 23

SIPLACE

Placement Systems

Adjusting the star with respect to the star’s magnetic neutral position

The aim of adjusting the star is to ensure that the vertical axis of segment no. 1 is aligned with

the magnetic neutral position of the star stepper motor.

¾ to do this, insert the star zero point correction tool in segment 1 and tighten it.

¾ pull off the motor power plug of the star motor from socket X5 on the intermediate distribution

board and connect the motor power to the power supply.

¾ connect the power supply unit to the main power

ATTENTION: maximum operation time should not

exceed 5 minutes

¾ tighten the M 3x8 hexagon socket head screws.

¾ remove the gauge pin.

¾ insert the gauge pin again into the gauge and into the segment hole, until it reaches the stop,

then check:

- that the gauge pin can be inserted easily

- that the star does not move from its current position.

¾ disconnect the power supply from the power source.

¾ repeat the adjustment procedure if the gauge pin does not slide easily into the hole.

Adjustments on Revolving Head