D-serie LEVEL II.pdf - 第37页
Overview Axis Unit and Computer Unit Assemblies S tude nt Guide Advanced Level 2 SIPLACE D Series EN 05/2007 Overview 3-13 Axis Controller Boards 3-8: Axis controller boards Axis Board A364 3-9: D4 axis board
Overview
Assemblies Axis Unit and Computer Unit
Student Guide Advanced Level 2 SIPLACE D Series
Overview EN 05/2007
3-12
Axis Unit SIPLACE D4
3-7: Axis Unit
The axis unit is located near the PCB input or output.
Servo Positions
NOTE:
The two power pack assemblies have a different version from 01/2007 and replace the
assemblies shown.
NOTE:
The various servo arrangements, which depend on the different machine configurations, can be
found as a table in the Head Modularity chapter.
Overview
Axis Unit and Computer Unit Assemblies
Student Guide Advanced Level 2 SIPLACE D Series
EN 05/2007 Overview
3-13
Axis Controller Boards
3-8: Axis controller boards
Axis Board A364
3-9: D4 axis board
Overview
Assemblies Pneumatic Unit
Student Guide Advanced Level 2 SIPLACE D Series
Overview EN 05/2007
3-14
3.4.4 Pneumatic Unit
The pneumatic unit is a fixed installation inside the machine and is located to the right of the middle
section of the machine, behind a flap. The pneumatic unit includes all electrical connections for control/
regulation of the compressed air supply.
See also:
J 5.3 Pneumatic System [J5-12]
3.4.5 Power Supply Unit
The main power supply unit is mounted on a compact rack module and is located on the left side of the
middle section. When viewed from the outside, only the red main power switch is visible.
A lockable door prevents access to the power supply.
See also:
J 5.2 Power Supply Unit [J5-2]
3.4.6 SIPLACE Vision
For a diagram of the camera, details and technical background, refer to the chapter "Communication and
Control".
See also:
J 4.4 SIPLACE Vision [J4-19]
3.4.7 Waffle Pack Changer (WPC)
NOTE: Further information
For further information about the WPC, refer to the relevant student guide or service manual.