SOM-1655-002.pdf - 第50页

49 Tg0742-PM-SO [Scan For Fitting] Button When this button is pressed, the following window appears. 0301-001 12.1 Adjustment for Sensor Head Installation Fig. 28 "Scan For Fitting" Window Operation Procedure (…

48 Tg0742-PM-SO0301-001

12.1 Adjustment for Sensor Head Installation

[All Beam Zero] Button (The left of the window)

Each of the X-, Y-, and L-axis are zeroed.

For actual proceed, press the [ON] button and then start by

pressing the [ENABLE] button on the operation panel.

[Jig Comp. Pickup & Fxd Camera Move] Button

After picking up the correction jig by the specified nozzle on the

specified head, the nozzle is moved into position for the camera

A1 and recognized by the camera.

Before this operation, the vacuum nozzle has to be

attached onto the head.

[Component Collection] Button

The correction jig picked up by the specified nozzle on the speci-

fied head is returned to the jig stocker.

• If the head and the nozzle for picking up the jig are not cor-

rectly specified, the jig cannot be returned.

• When the sensor head position is moved, the jig stocker posi-

tion is also changed and the jig cannot be correctly returned. In

this case, remove the jig manually, and return the jig to the

stocker after the jig returning operation of the machine.

[Rough Positioning] Button

The jig is moved to the center of the detection area for rough

positioning of the sensor head.

Before this operation, the vacuum nozzle has to be

attached to the head.

49 Tg0742-PM-SO

[Scan For Fitting] Button

When this button is pressed, the following window appears.

0301-001

12.1 Adjustment for Sensor Head Installation

Fig. 28 "Scan For Fitting" Window

Operation Procedure

(1) Select the head and nozzle to be detected. When the indi-

vidual head and nozzle are selected, this selected vacuum

nozzle operates as the nozzle of arrangement No. 1 (down-

ward).

When [All Heads] and [All Nozzles] are selected, before this

operation, reset the nozzle which has been already attached

to the head in the nozzle stocker, and put the nozzle for

picking up the correction jig in the No. 10 stocker in the

nozzle stocker B1.

(2) For "Scan Times", the number of detection operations is set.

Normally, set it to 6.

(3) For "Direction", the direction of the jig used for the detection

is set.

It is required to set "All Heads" and "All Nozzles" and detect

them at all specified angles.

50 Tg0742-PM-SO

[Scan Reference Nozzle] Button

After "Scan For Fitting" operation, the reference nozzle is de-

cided. Then the reference nozzle is used to detect. As the sensor

head installation condition is found on the basis of the detections,

the sensor head position is so adjusted that it is close to the

target value.

When this button is pressed, the following window appears.

0301-001

12.1 Adjustment for Sensor Head Installation

Fig. 29 "Scan Reference Nozzle" Window