SOM-1655-002.pdf - 第63页

62 Tg0742-PM-SO 12.4 Offset T eaching Procedure (1) Perform "Scan Start (NC-Axis)". Put the correction jig on the jig stocker so that its mirror side is turned down. Return to the nozzle stocker all nozzles att…

61 Tg0742-PM-SO0301-001

12.3 Offset Teaching

• For "Scan Times", set the number of detection operations.

Standard: 6 times

• When the head and nozzle to be detected are specified, the

unit detects and calculates the offset value for the NC-axis.

[Scan Start] Button

• The detecting is done by means of scanning the correction jig,

and offset values for X-, Y- and L-axis are calculated. In addi-

tion, the detection and calculation for the W1, W2, W3, Xfr

speed and Incr. (correction jig size) are performed.

• For "Scan Times", set the number of detection operations.

Standard: 6 times

After performing [Scan Start (NC-Axis)], perform [Scan

Start].

[Mnl Noz Chng] Button

The "Mnl Noz Chng" window appears.

[Clear Adj] Button

The detected data is cleared.

[Cancel] Button

While the teaching window is displayed, no other operations are

available. In this case, if there is to be another operation, the

teaching function must be stopped by using this button.

[End] Button

The detected and adjusted values are saved as offset data.

[Return] Button

The previous window appears.

62 Tg0742-PM-SO

12.4 Offset Teaching Procedure

(1) Perform "Scan Start (NC-Axis)".

Put the correction jig on the jig stocker so that its mirror side is

turned down.

Return to the nozzle stocker all nozzles attached to the nozzle

clamp in the head.

Select [Scan Start (NC-Axis)] in the "Offset Teaching" window

and set the "Scan Times" to about 6 for all heads and all

nozzles. Then, perform [Scan Start (NC-Axis)].

(2) Check that the [Recognition Dsbl.] mode is not set.

(3) Start scanning.

Select [Scan Start] in the "Offset Teaching" window and set the

"Scan Times" to about 6 for all heads and all nozzles. Then

perform [Scan Start].

(4) Save the measured data.

Press the [End] button to save the adjusted values as offset

data.

0301-001

12.4 Offset Teaching Procedure

63 Tg0742-PM-SO0307-002

13. LAN Setting

LAN setting procedure is described here for the V. bend detection

unit.

13. LAN Setting

• Check the computer name, IP address and subnet mask used in the

V. bend detection unit, in advance.

(a) Take care that the same IP address in other machines

cannot be used.

(b) The IP address setting is required, so that it can be

accessed with the IP Address and subnet mask settings

in TIM-X100.