SOM-1655-002.pdf - 第64页

63 Tg0742-PM-SO 0307-002 13. LAN Setting LAN setting procedure is described here for the V . bend detection unit. 13. LAN Setting • Check the computer name, IP address and subnet mask used in the V . bend detection unit,…

62 Tg0742-PM-SO

12.4 Offset Teaching Procedure

(1) Perform "Scan Start (NC-Axis)".

Put the correction jig on the jig stocker so that its mirror side is

turned down.

Return to the nozzle stocker all nozzles attached to the nozzle

clamp in the head.

Select [Scan Start (NC-Axis)] in the "Offset Teaching" window

and set the "Scan Times" to about 6 for all heads and all

nozzles. Then, perform [Scan Start (NC-Axis)].

(2) Check that the [Recognition Dsbl.] mode is not set.

(3) Start scanning.

Select [Scan Start] in the "Offset Teaching" window and set the

"Scan Times" to about 6 for all heads and all nozzles. Then

perform [Scan Start].

(4) Save the measured data.

Press the [End] button to save the adjusted values as offset

data.

0301-001

12.4 Offset Teaching Procedure

63 Tg0742-PM-SO0307-002

13. LAN Setting

LAN setting procedure is described here for the V. bend detection

unit.

13. LAN Setting

• Check the computer name, IP address and subnet mask used in the

V. bend detection unit, in advance.

(a) Take care that the same IP address in other machines

cannot be used.

(b) The IP address setting is required, so that it can be

accessed with the IP Address and subnet mask settings

in TIM-X100.

64 Tg0742-PM-SO0307-002

13.1 IP Address Setting Procedure

This explains on Japanese screen.

(1) If the TIM-X100 has been connected to the LAN before the

power is turned on, disconnect.

(2) Turn on the power.

(3) Start up the machine.

(4) Press the [ctrl] key twice on the keyboard and switch to the V.

bend detection unit window.

(5) Re-start the V.bend detection unit

• Operation Sequence : “Start”

→ “Shutdown” → “Re-start”.

(6)

During the start-up operation, press the [↓] key in the

“Write Enable / Disable Section” window (Fig. 36) and

select “write enable”, then start up the V. bend detection

unit in the write enable mode.

Fig. 36 “Write Enable / Disable Section” window