192277 - Micron Technical Reference Volume 3.pdf - 第203页
FOREIGN MACHINE INTERFACE INTRODUCTION Chapter Issue 5, Aug 14 Technical Reference Manual 33.1 CHAPTER 33 FOREIG N MACHINE INTERF ACE INTRODUCTION The Foreign Machine Interface (FMI) is an electrical means of communicati…
BARCODE READER AND VERIFICATION AND TRACEABILITY
BARCODE READER SET UP
32.14 Technical Reference Manual Chapter Issue 10, Feb 17
BARCODE READER SET UP
For configuring and setting up the barcode reader, contact your local customer
support office.
Complex Codes For reading complex codes or where a barcode read is particularly problematic,
it may be necessary to position the reader head with better precision.
The reader angle
from the perpendicular
must be approximately
30 degrees and, parallel
to the plane of the
product.
30
FOREIGN MACHINE INTERFACE
INTRODUCTION
Chapter Issue 5, Aug 14 Technical Reference Manual 33.1
CHAPTER 33 FOREIGN MACHINE INTERFACE
INTRODUCTION The Foreign Machine Interface (FMI) is an electrical means of communication
between the DEK machine and an adjacent machine/conveyor, using electrical
signals. The signals are transferred using opto-couplers and/or solid state
relays which keep the machines electrically isolated.
The DEK machine can interface with many different types of adjacent machine.
The machines utilize a set of timing and control signals (protocols) for commu-
nication with adjacent machines. There are two different types of interface
available for the DEK machine:
• An FMI Pod for SMEMA, Fuji or Panasonic protocols
• A Multi-Interface Unit (MIU) for all other protocols
The FMI Pod and the MIU are supplied with the following cables:
• An FMI loom which connects the FMI port on the machine controller, to the
MIU or FMI Pod
• Two interface cables, one cable for each adjacent machine
The adjacent machine/conveyor can be in the following configurations:
Figure 33-1 Machine Arrangements for Board Transfers
Left to Right Board Transfers
Right to Left Board Transfers
Upline
Downline
UplineDownline
Left to Left Board Transfers Right to Right Board Transfers
Upline
Downline
Upline
Downline
DEK
Machine
DEK
Machine
DEK
Machine
DEK
Machine
Adjacent
Machine/
Conveyor
Adjacent
Machine/
Conveyor
Adjacent
Machine/
Conveyor
Adjacent
Machine/
Conveyor
Adjacent
Machine/
Conveyor
Adjacent
Machine/
Conveyor
Adjacent
Machine/
Conveyor
Adjacent
Machine/
Conveyor
FOREIGN MACHINE INTERFACE
FMI POD
33.2 Technical Reference Manual Chapter Issue 5, Aug 14
FMI POD The FMI Pod is only used where both the upline and downline are using
SMEMA, Fuji or Panasonic interfaces. For all other interfaces refer to the MIU
interface later in this chapter.
The FMI Pod is a communications interface that allows DEK Printing Machines
to communicate with upline and downline board handlers.
NOTE
The FMI Pod is located at the front of Type 4 machines and accessed by
removing the front panel.
External Service Panel
M28SK02
POWER ON
PART No. 160740
M/C AVAILABLE
BOARD AVAILABLE
BOARD FAIL
DOWNLINE
BOARD AVAILABLE
BOARD FAIL
M/C AVAILABLE
UPLINE
M28PL01
FMI POD