M8_ServiceManual_e.pdf - 第18页

1 Installation 1-4 Production Line To align your assembly line, first in stall the heaviest unit. Then install peripheral un its using the first un it as a reference. Reference Loader Mount er Reflow Oven Conv eyor Unloa…

1 Installation

1-3

How to Hoist the Machine

Use the wires and the arm as follows.

NOTE: Be sure to use the arm to prevent the wire from touching the machine.

Front View

Side View

Arm

Wire

Arm

1 Installation

1-4

Production Line

To align your assembly line, first install the heaviest unit. Then install peripheral units using the first unit as

a reference.

Reference

Loader　　　　Mounter　　　　　Reflow Oven　　　Conveyor Unloader

To transfer the PCB (printed circuit board) smoothly, clearance between units are quite important. Be sure

that the clearance between units is 5 mm or less as below figure shows. Adjust the height of the downstream

unit a little lower (0-0.5 mm) so that the PCB is transferred smoothly.

0 - 0.5mm

5mm or less

Downstream Upstream

側

1 Installation

1-5

Installing the Machine

Do not touch terminals of electric components when the power is on to prevent electric shock and machine

damage.

Make sure to ground the machine to prevent electric shock.

Note on Installation

It is normal that the adjust foot can be slightly inclined (within 2-degree range).

Do not tighten the bolt forcedly trying to fix the foot.

When you move and/or install the mounter, be careful not to apply excessive

force on the adjust foot. This may cause the screw of the adjust foot to break.

When placing the mounter on the floor, be sure that the mounter is kept

horizontal.

Warning

2°

If excessive force is

applied, the screw may

break at this point.

Mounting Screw

Nut

Adjust foot