M8_ServiceManual_e.pdf - 第30页
1 Installation 1-16 Sequence of Receiving PC board (Standard spec.) ① When the machine is ready to r eceive PC board, Permit Transfer (M achine Not Ready) is sent to Pre-process machine. ② The transfer belt will be activ…
1 Installation
1-15
Pre-Process and Post-Process of Machine
Connecting Pre-Process and Post-Process
When using other manufacturer’s machines as the pre-process or post-process, connect them as shown in
the below diagram. No-voltage output (relay) is recommended for post-process.
Standard spec. : Upper half of the diagram.
SMEMA Interface spec. : Whole diagram.
＊INPUT
CIRCUIT
＊INPUT
CIRCUIT
2
1
CN2 CN1
Post-process
Connector (Cable side)
AMP
206044-1(plug)
66099-2 or equivalent (pin)
206070-1(cable clamp)
Connector (Mounter side)
AMP
206043-1(receptacle)
Mounter Pre-process
BOARD
AVAILABLE
BOARD
AVAILABLE
MACHINE
NOT READY
4.7KΩ
4.7KΩ
Input
terminal
＊INPUT CIRCUIT
+5V
30VDC 1A or less
100VAC 0.5A or less
RELAY
RELAY
MACHINE
NOT READY
3
4
2
1
3
4
COM
1 Installation
1-16
Sequence of Receiving PC board (Standard spec.)
① When the machine is ready to receive PC board, Permit Transfer (Machine Not Ready) is sent to
Pre-process machine.
② The transfer belt will be activated when the Permit Transfer and the Entrance Sensor turn on.
③ The Permit Transfer will be sent-off when Entrance Sensor turns on.
④ The transfer belt will be deactivated when the Arrival Sensor turns on.
⑤ “Conveyor Trouble” error happens if the Arrival Sensor does not turn on or the Entrance Sensor does
not turn off within 10 seconds after the transfer belt was activated.
⑥ Pressing START button restarts the operation paused by the error.
Permit Transfer to
Pre-process machine
(Machine Not Ready)
Permit Transfer to
Pre-process machine
(Machine Not Ready)
Transfer Belt
Arrival Sensor
Entrance Sensor
OR
Entrance Sensor
① ③
① ③
②
④
1 Installation
1-17
Sequence of Sending PC board (Standard sepc.)
① The transfer belt will be activated when the machine is ready to send PC board and the Permit Transfer
(Machine Not Ready) is received form the Post-process machine.
② The transfer belt will be deactivated when the Exit Sensor turns off after the sensor turns on at the PC
board arrive and it passed under the sensor.
③ “Conveyor Trouble” error happens if the Exit Sensor does not turn on or the sensor does not turn off
from turning on within 10 seconds after transfer belt was activated
④ Pressing START button restarts the operation by the error.
Permit Transfer from
Post-process machine
(Machine Not Ready)
Permit Transfer from
Post-process machine
(Machine Not Ready)
Exit Sensor
Transfer Belt
Available Transfer
OR
Available Transfer
① ②