M8_ServiceManual_e.pdf - 第55页

3 Mechanical Section 3-15 Nozzle Recognition Stickers Labeling a Nozzle ID Sticker to a Nozzle ACTION: ① From the surface to which the sticker is to be affi xed, rem ove oil, dust and water content completely using indus…

3 Mechanical Section

3-14

■ Attaching O-ring and Nozzle Filter

ACTION:

① Insert the filter with tweezers and adjust the position of the filter using the O-ring insertion jig.

Correct Incorrect

② Set the O-ring at the tip of the nozzle and push it slowly using the O-ring insertion jig to the bottom of

the nozzle.

③ Remove the jig slowly.

④ Check that the filter and the O-ring have been set in place correctly.

3 Mechanical Section

3-15

Nozzle Recognition Stickers

Labeling a Nozzle ID Sticker to a Nozzle

ACTION:

① From the surface to which the sticker is to be affixed, remove oil, dust and water content completely

using industrial alcohol.

② Pull out the shaft of the nozzle sticker tool approx. 3mm from the ring.

③ Peel the sticker from the paper using tweezers.

④ Place the sticker with its adhesive side up, and then put it in the jig (make sure that the D-cut on the

sticker is aligned with that on the ring). (The sticker must be angled so that the nozzle ID no. is

oriented as illustrated below.) Take care not to touch the adhesive surface with fingers.

⑤ Push the nozzle into the shaft. Make sure that the nozzle’s notch is aligned with the positioning slot on

the ring.

⑥ While pressing the nozzle’s rim, push the shaft into the ring so that the sticker is affixed onto the

nozzle.

⑦ Check that the sticker touches the bottom of the ring.

NOTE: If the shaft is pulled out of the ring too much, it may come off. If it comes off, align the shaft’s slot with the

ring’s positioning pin and then insert the shaft into the ring slowly.

Part Name

Part No. Remark

ID SEAL TOOL, ASSY. LC1-M8903-00X ID sticker tool

Nozzle ID sticker tool

D-cut

Shaft

Positioning pin

Ring

Positioning slot

Nozzle ID sticker

Nozzle

Notch

ID No. (P***)

3mm

3 Mechanical Section

3-16

Cleaning Nozzle Recognition Stickers

Dirt on nozzle ID/presence stickers can be a cause of vision recognition failure. Regularly clean the nozzle

ID/presence stickers.

ACTION:

① Clean the sticker with cotton swab soaked with alcohol.

② Wipe off the remaining alcohol on the sticker with dry cotton swab.

NOTE: Particularly the nozzle ID stickers are liable to get dirty. If a nozzle ID sticker becomes too dirty to be

cleaned, replace it with new one.

For the part No. for the nozzle ID sticker, refer to “5. Materials”.

NOTE: The nozzle ID/presence stickers are easily peeled off when they get wet. Be sure to dry them with cotton

swab whenever they get wet.