M8_ServiceManual_e.pdf - 第19页

1 Installation 1-5 Installing the Machine Do not touch terminals of electric com ponents when the power is on to prevent el ectric shock and machine damage. Make sure to ground the machi ne to prevent electric shock. Not…

1 Installation

1-4

Production Line

To align your assembly line, first install the heaviest unit. Then install peripheral units using the first unit as

a reference.

Reference

Loader　　　　Mounter　　　　　Reflow Oven　　　Conveyor Unloader

To transfer the PCB (printed circuit board) smoothly, clearance between units are quite important. Be sure

that the clearance between units is 5 mm or less as below figure shows. Adjust the height of the downstream

unit a little lower (0-0.5 mm) so that the PCB is transferred smoothly.

0 - 0.5mm

5mm or less

Downstream Upstream

側

1 Installation

1-5

Installing the Machine

Do not touch terminals of electric components when the power is on to prevent electric shock and machine

damage.

Make sure to ground the machine to prevent electric shock.

Note on Installation

It is normal that the adjust foot can be slightly inclined (within 2-degree range).

Do not tighten the bolt forcedly trying to fix the foot.

When you move and/or install the mounter, be careful not to apply excessive

force on the adjust foot. This may cause the screw of the adjust foot to break.

When placing the mounter on the floor, be sure that the mounter is kept

horizontal.

Warning

2°

If excessive force is

applied, the screw may

break at this point.

Mounting Screw

Nut

Adjust foot

1 Installation

1-6

ACTION:

① Locate the machine to the specified place.

② Remove metal fittings that fasten Head Unit, X and Y Beams, in order to prevent to move during

transportation, and also detach cushions put in the head cable bear. After that, check to see that the X

beams and heads can move to the Y direction manually.

③ Five ropes can be taken off if five points have been removed.

Note; Please keep the metal fittings, they will be needed when moving the machine.

④ When the machine is installed stand alone, turn the adjust feet so that the PCB transfer height is the

same as the conveyor height (900±20mm (see Note)) of the reference equipment. In the case of

SMEMA interface spec, the height must be 950±20mm.

④ When the machine is connected to the Pre-process on production line, adjust the PCB transfer height

to the conveyor rail height of the Pre-process.

)

Production Line

出荷時の内部写真（背面側）

X 軸 Y 軸ヘッド