M8_ServiceManual_e.pdf - 第23页

1 Installation 1-9 Air Regulator Instruction Pressure; 0.45MPa Intake-side air coupler 65SN/85SN (Nitto Kohki) or equivalent

1 Installation

1-8

⑥ After the machine is positioned, make sure that a board runs smoothly between upstream and

downstream conveyors.

⑦ Place a leveler on the Y beam and make a fine adjustment so that the difference in leveler when the Y

beam moves rightward and leftward will be within 1 scale (1 scale is 0.02mm/m). (To prevent a Y

beam distortion.)

⑧ Lock the adjust foot nuts lastly.

NOTE: The adjust foot nuts must be locked with a closed wrench (nominal: 46mm) or a single-head wrench.

⑨ Connect the power cable and ground line independently of other machines which may be a noise

source, such as a compressor, welding machine.

⑩ Connect an intake-side air coupler 65SN or 85SN (Nitto Kohki) or equivalent to the air regulator

coupler located on the rear of the machine. After the coupler is connected, make sure that the air

regulator’s reading is 0.45MPa

Lever

Put the lever at the middle of

Y Beam.

1 Installation

1-9

Air Regulator

Instruction Pressure; 0.45MPa

Intake-side air coupler

65SN/85SN (Nitto Kohki) or equivalent

1 Installation

1-10

Supplementary Explanation for Installation

When setting up a production line, level adjustment and line positioning of the machine may be carried out

at the same time. However, to fine-adjust the machine position with the machine level, i-PULSE

recommends that the machine be roughly positioned to the production line first, and then be leveled and

positioned accurately using the following four sets comprising a hydraulic jack and plates.

ACTION:

① Bond the non-slip base rubber with base plate 2.

② Apply grease between base plates 1 and 2 for lubrication purposes.

③ Place a plate set near each machine jack-up point (four points).

④ Place a jack on each plate set and jack up the machine.

⑤ Adjust each jack so that the machine is level.

⑥ Fine-adjust the position of the machine while the machine is jacked up. (The machine can be moved

lengthwise and crosswise with help of grease applied between the plates.)

Hydraulic jack

Base plate 1

Base plate 2

Base rubber

Apply grease

between the

lates.

Hook stroke