00191369-02.pdf - 第178页
5 Single Functions User Manual HS -50 5.3 Single functions, Transport Software Version S R.501.xx 12 /99 Issue US 178 t I I t 5 The conveyo rs are trave ling at th e set spe ed. All func tions are loc ked. 5 Å Click the …
User Manual HS-50 5 Single Functions
Software Version SR.501.xx 12/99 Issue US 5.3 Single functions, Transport
177
t IIt
Refresh 5
The "Refresh" function is used to check whether the ultrasonic sensors for the whole of the trans-
port conveyor are adjusted correctly. To do this, position a board over one of the sensors. 5
The most recent states of the light barriers for the input conveyor (IC), processing conveyor 1
(PC1), intermediate conveyor (IC), processing conveyor 2 (PC2) and output conveyor (OC) are
displayed above the "Refresh" button. When you execute the "Refresh" function the current states
are queried and the results displayed (see Fig. 5.3 - 1
). 5
Å Position a board over the sensor for the required conveyor.
Å Click the Refresh button in the "Sensor state" area.
The sensors are updated and the result is displayed over the button.
There are two possible states for each sensor: 5
1 = The sensor has responded.
There is a board on this conveyor. 5
0 = The sensor has not responded.
There is no board on this conveyor. 5
Å Repeat the process for each of the transport conveyors, if necessary.
On 5
This function can be used to check the conveyors at both slow and high speed. The input conveyor
only travels at high speed. 5
NOTE
The conveyor must be empty before carrying out this function. 5
Å Click the PCB to output conv. button in "Processing area 2" to empty the conveyor.
Å Activate the "High speed" check box in the "Conveyor" area if the conveyor is to travel at high
speed.
Å Deactivate the check box if the conveyor is to travel at the slower speed.
NOTE
The input conveyor only travels at high speed. 5
Å Click the On button. This opens the following dialog box.
5 Single Functions User Manual HS-50
5.3 Single functions, Transport Software Version SR.501.xx 12/99 Issue US
178
t IIt
5
The conveyors are traveling at the set speed.
All functions are locked. 5
Å Click the OK button in this dialog box if the operation is to be stopped.
The conveyors will be stopped and the dialog box closed.
All functions are then released.
5
User Manual HS-50 5 Single Functions
Software Version SR.501.xx 12/99 Issue US 5.3 Single functions, Transport
179
t IIt
5.3.2 "PCB conveyor width" screen
5
Å In the "Transport functions" screen, click the symbol.
The user interface is switched to the "PCB conveyor width" screen (see Fig. 5.3 - 2
).
5
Fig. 5.3 - 2 "PCB conveyor width" screen
5
CAUTION
Before adjusting the conveyor width, make sure there are no boards or other objects on the
machine’s conveyors. Failure to do so may result in damage to both machine and boards!
5