00191369-02.pdf - 第373页
User Manual HS-50 10 Component handling Software V ersion SR.501.xx 12/99 Issue US 10.5 Used tape cut ter 373 t I I t 10.5 Used t ape cutter 10 Fig. 10.5 - 1 Position of the used tape cutter Key to Fig. 10.5 - 1 (1) Used…
10 Component handling User Manual HS-50
10.4 Tape container Software Version SR.501.xx 12/99 Issue US
372
t IIt
10.4 Tape container
10.4.1 Overview
Reels up to 15" in diameter may be used, although for 15" reels you should use spindles as well.
Insert the spindles into the partitions as shown in Fig. 10.4 - 1
. 10
PLEASE NOTE 10
We recommend that you use spindles if the tape reel diameter exceeds 5". This will ensure that
the feeder modules operate reliably.
Fig. 10.4 - 1 Component table and tape container
(1) Component table (2) Spindle position for 15" reels
(3) Waste tape container (4) Partition
(5) Tape container (6) Spindles
10 Component handling User Manual HS-50
10.5 Used tape cutter Software Version SR.501.xx 12/99 Issue US
374
t IIt
10.5.1 General
The placement system has a used tape cutter at each of the four component table locations. It is
used to cut off the waste tape. The cut pieces of tape drop into the waste tape container in the
component table. 10
Å Empty the waste tape container every day.
Fig. 10.5 - 2 Used tape cutter
Key to Fig. 10.5 - 2
(1) Pneumatic cutting device
(2) Short-stroke lifting cylinder
(3) Opening for removal of the used tape