OM-1606-006w_GT-28x.pdf - 第119页
OM-1606 6. Splicing 6-17 Peel off the white peeling paper on the other backing tape. Adhere the backing tape to the rear side (embossed bottom surface) of the cover tape so that the joint position is located at the cente…
OM-1606
6-16
6. Splicing
6.6.3 Tape Splicing Procedure
(For 12 mm : FC12QE, 10896-96-430 (For backing), For 16 mm :
FC16QE, 10896-96-430 (For backing))
Note
When part of black tape is left on the peeling paper, return the peeling
paper and press the tape against the paper. Then, peel off the peeling paper
again.
Peel off the white peeling paper on
the splicing tape.
As there is a margin for peeling, peel
it from that section.
First, adhere the cover tape surface
of the new tape onto the splicing
tape.
Align the tape border on the opposite
side of the sprocket hole with the
reference guide, and so adhere it
that the joint position is located at the
center.
Adhere the cover tape surface on the
feeder side.
Align the tape border on the opposite
side of the sprocket hole with the
reference guide, and so adhere it that
there is no gap on the joint position
with the new tape.
Bend the splicing tape along the
perforations and adhere it onto the
carrier tape on the sprocket hole
border side.
In order to adhere the splicing tape
securely, press and rub the surface
of the transparent tape entirely.
Peel off the transparent lm.
0908-001
1
2
3
4
5
OM-1606
6. Splicing
6-17
Peel off the white peeling paper on
the other backing tape.
Adhere the backing tape to the rear
side (embossed bottom surface)
of the cover tape so that the joint
position is located at the center.
Peel off the transparent lm.
Conrm that the splicing tape has
been adhered securely to the cover
tape and the carrier tape surfaces.
When the tape has been spliced
securely, the procedure is completed.
0908-001
6
7
8
9
OM-1606
6-18
6. Splicing
0908-001
6.6.4 Precautions
(1) When the carrier tape is cut or spliced, take care so that the
component feed pitch does not slide.
Otherwise, the pick-up error might occur.
(2) Cut and splice the carrier tape so that there is no gap, overlap or
deviation of the carrier tape on the joint position.
Cut the tape at an angle of 90 degrees to the long side and at the
same position, based on the sprocket hole.
If there is any gap, overlap or deviation, a feed error might occur.
Gap
Overlap
Deviation