OM-1606-006w_GT-28x.pdf - 第156页
OM-1606 7-6 7. Maintenance 7.4.2 Suppressor Section Upper Surface of Suppressor Every Day Cleaning Remove dirt and dust with a vacuum cleaner and wipe the surface clean with a rag. Remove dust such as paper fiber accumul…
OM-1606
7-5
7. Maintenance
7.4 Maintenance Spots
7.4.1 Description of Maintenance in Each Section
Here the maintenance cycle for each section of the tape feeder.
GT-28080 is given as the example in the description of the procedure.
This procedure applies to almost all the tape feeders, except for those with special
descriptions.
How to Locate the Check, Cleaning, Lubrication and Adjustment Spots
Chute
Every week Cleaning
Lift the suppressor and clean it with a rag
soaked in alcohol.
(a) When the chute is cleaned,
remove the Magnetic Plate.
If the tape is set with any foreign
substance attached, it might
cause a suppressor deformation
or pick-up error.
[1]
[2]
[3]
Notice
(b)
FG1
[1]
: Maintenance Spot
[2]
: Maintenance Cycle and Contents
[3]
: Details of Maintenance
0908-001
OM-1606
7-6
7. Maintenance
7.4.2 Suppressor Section
Upper Surface of Suppressor
Every Day Cleaning
Remove dirt and dust with a vacuum cleaner
and wipe the surface clean with a rag.
Remove dust such as paper fiber accumulated
in the tape peeling section, using a toothbrush.
FG2
Chute
Every week Cleaning
Lift the suppressor and clean it with a rag
soaked in alcohol.
(a) When the chute is cleaned,
remove the Magnetic Plate.
(b)
Notice
If the tape is set with any foreign
substance attached, it might
cause a suppressor deformation
or pick-up error.
FG3
Suppressor (Rear Side)
Every week Cleaning
Notice
Lift the suppressor and clean it with rag soaked
in alcohol or cotton swab.
If the tape is set with any foreign
substance attached, it might cause
a suppressor deformation or
pick-up error.
FG4
0908-001
OM-1606
7-7
7. Maintenance
Peeling Section
Every week Cleaning
Notice
If the cover tape is set while it has
any debris of cover tape on it,
then it might cause suppressor
deformation or pick-up error.
Lift the suppressor and clean it with a Cotton
swab or toothbrush.
FG5
Pick-up Position
Every Three Months Check, Adjustment
Check the pick-up position, using the feeder adjusting jig
JG-0209 (Purchase separately).
If the pick-up position is not correct, adjust it.
FG6
0908-001