OM-1606-006w_GT-28x.pdf - 第160页

OM-1606 7-10 7. Maintenance 7.4.5 Joint Detection Unit Tape Guide on the Joint Detection Unit (Only for GD-28080, GD-28081, GD-28082, GD-28083, GD-12162, GD-24322, GD-44562, GD-72002 and GD-88002) Every week Cleaning • F…

100%1 / 235
OM-1606
7-9
7. Maintenance
7.4.4 Component Discharging Section
Air Blow
Discharging Outlet
Every week Cleaning
Blow the air in the direction of
the discharging outlet.
(The components are discharged
from the opening opposite to this
outlet).
When any component is
removed using air-blow,
the components might
scatter around, so perform
this operation paying
attention to the surrounding
condition.
Note
FG8
0908-001
OM-1606
7-10
7. Maintenance
7.4.5 Joint Detection Unit
Tape Guide on the Joint Detection Unit
(Only for GD-28080, GD-28081, GD-28082,
GD-28083, GD-12162, GD-24322, GD-44562,
GD-72002 and GD-88002)
Every week Cleaning
• For GD-28080, GD-28081, GD-28082 or
GD-28083, lift the cover and remove any alien
substance using the applicator or bamboo probe.
•
If any foreign substance is attached
when the tape is passed through,
it might damage the joint detection
sensor or cause a tape feeding error.
In the case of GD-28080, GD-28081,
GD-28082 or GD-28083
Sensor Section
Refer to "7.5.2 8 mm Dual Feeder
Joint Detection Unit Sensor Section
Cleaning (For GD28080, D-28081,
GD-28082 or GD-28083) " for details.
For GD-12162, GD-24322, GD-44562, GD-72002
or GD-88002, remove any alien substance from
under the joint detection unit, using the applicator
or bamboo probe.
Reference
Notice
FG9
1011-002
OM-1606
7-11
7. Maintenance
7.4.6 Tape Feed Gear Section
Worm Gear
Every Three Months Cleaning, Lubrication
Remove the dust protective cover and remove dust and debris using a cloth
or bamboo probe. Then, apply MOLYNOC Grease AP1 using the greasing jig.
Greasing Jig
Refer to "7.5.1 How to Apply Grease to the Sprocket Driving Gear
Unit" for details.
Reference
FG10
7.4.7 Cover Tape Take-up Gear Section
Flat End Wheel, Worm Gear, Worm Wheel (Right Side, Left Side)
Every Three Months Cleaning, Lubrication
Remove the cover and remove dust and debris using a cloth or bamboo probe.
Then, apply MOLYNOC Grease AP1 using the greasing jig.
Flat End Wheel
Worm Gear
The illustration shows the left side of the unit.
However, apply the same procedure also
to the right side of the unit.
Worm Wheel
Cover
FG11
0908-001