OM-1606-006w_GT-28x.pdf - 第67页
OM-1606 2. Attachment and Detachment of T ape 2-35 Magnetic Plate Attachment Position • Magnetic Plate Appearance The appearance of the magnetic plate taken out from the housing section is as shown in FB44. Set Hole FB44…
OM-1606
2-34
2. Attachment and Detachment of Tape
2.8.1 How to attach the Magnetic Plate for 12 mm and 16 mm Width Tape
Procedure
(1) Take out the magnetic plate from the housing section.
Remove the set screw (countersunk head screw) using a precision screw
driver.
The removed set screw is used when the magnetic plate is attached to the
chute section.
(2) Take it out drawing it in the arrow direction.
(For housing)
When it is to be housed, use the reverse procedure. Press the magnetic plate
from above and deform it a little to house it in the housing section.
Magnetic Plate
Set Screw
(Countersunk Head Screw)
Direction of Unreeling
FB43
1005-002
OM-1606
2. Attachment and Detachment of Tape
2-35
Magnetic Plate Attachment Position
•
Magnetic Plate Appearance
The appearance of the magnetic plate taken out from the housing section is as
shown in FB44.
Set Hole
FB44
•
Magnetic Plate Set Hole and Installation Location
The magnetic plate and tape feeder have two set holes each.
The set hole to be used for 12 mm tape, is different from that for 16 mm tape.
Magnetic Plate
Chute section
Magnetic Plate
Chute section
For using tape with 12 mm
For using tape with 16 mm
FB45
0908-001
OM-1606
2-36
2. Attachment and Detachment of Tape
Magnetic Plate Attachment when the 12 mm Width Tape is used
Fix the magnetic plate with the set holes for 12 mm width tape aligned, so that
the magnetic plate is located at the center of the chute.
Chute Center Position
Set Hole Position
Set Screw
(Countersunk Head Screw)
Magnetic Plate
Chute section
FB46
Magnetic Plate Attachment when the 16 mm Width Tape is used
Fix the magnetic plate with the set holes for 16 mm width tape aligned, so that
the magnetic plate is located at the center of the chute.
Chute Center Position
Set Hole Position
Set Screw
(Countersunk Head Screw)
Magnetic Plate
Chute section
FB47
Note
After the use of the magnetic plate, remove it from the chute section and
house it in the magnet plate housing section.
When it is left after the removal, it might cause deformation or losing.
0908-001