OM-1606-006w_GT-28x.pdf - 第130页

OM-1606 6-28 6. Splicing 6.8.3 T ape Splicing Procedure (For 24 mm or more : FC24QE) Note When part of black tape is left on the peeling paper , return the peeling paper and press the tape against the paper . Then, peel …

OM-1606

6. Splicing

6-270908-001

6.8.2 Cutting Tape on Feeder Side

(1) Prepare the tape on the feeder side.

(2) Cut the tape on the feeder side.

Set the tape on the pilot pins and cut

it.

•

Take care not to cut any component

in order to prevent damage to the

tape cutting jig.

•

In the case of 12 mm or 20 mm pitch,

the pilot pins are not used.

(3) The preparation of the tape on the

feeder side has been completed.

If it tends to bend, correct it.

•

In the case of 12 mm or 20 mm pitch,

do not use the pilot pins. Cut the tape

at the center position between the

two carrier pockets.

Cut the tape so that the carrier tapes

are not overlapped each other at the

joint section.

Feeder Side

Section where the

components are

not included

Section where the

components are included

Cut Position

OM-1606

6-28

6. Splicing

6.8.3 Tape Splicing Procedure (For 24 mm or more : FC24QE)

Note

When part of black tape is left on the peeling paper, return the peeling

paper and press the tape against the paper. Then, peel off the peeling paper

again.

Cut off the splicing tape along the

perforations.

Peel off the white peeling paper

on the splicing tape up to the

perforations and bend it.

First, adhere the cover tape surface

of the new tape onto the splicing

tape.

Align the bent perforations with the

tape border of the sprocket hole side

and so adhere it that the joint position

is located at the center.

Adhere the cover tape surface on the

feeder.

Align the bent perforations with the

tape border of the sprocket hole side

and so adhere it that there is no gap

on the joint position with the new

tape.

Peel off the peeling paper, bend the

splicing tape along the perforations

and adhere it onto the carrier tape on

the sprocket hole border side.

In order to adhere the splicing tape

securely, press and rub the surface

of the transparent lm entirely.

0908-001

OM-1606

6. Splicing

6-29

Peel off the transparent lm.

Peel off the white peeling paper on

the splicing tape which has been cut

in Step 1 .

Adhere it to the rear side (embossed

bottom surface) of the cover tape so

that the joint position is located at the

center.

Peel off the transparent lm.

Conrm that the splicing tape has

been adhered securely to the cover

tape and the carrier tape surfaces.

When the tape has been spliced

securely, the procedure is completed.

0908-001