APC - 224650 Issue 1.pdf - 第91页
ALL PURPOSE CLAMPING (APC) MAINTENANCE SCHEDULE Chapter Issue 1 Nov 16 All Purpose Clamping (APC) Manual 1.79 Weekly Mainte nance W ARN ING HARMFUL SUBST ANCES. CLE ANING WIPES AND CLEANING S OLUTIONS MA Y CONT AIN SUBST…
ALL PURPOSE CLAMPING (APC)
MAINTENANCE SCHEDULE
1.78 All Purpose Clamping (APC) Manual Chapter Issue 1 Nov 16
MAINTENANCE SCHEDULE
This maintenance schedule is a recommended programme of cleaning and
checks for APC system specific equipment, which should be carried out on a
weekly, quarterly and yearly basis. It should be run in conjunction with the
Preventive Maintenance schedule found in the printer’s Micron Technical Ref
-
erence manual.
The schedule can only be performed by a suitably trained engineer.
Material Safety
Data Sheets
Material Safety Data Sheets (MSDS) listing the health and safety aspects
applicable to cleaning materials are available on request from the purchase
source.
If difficulty is experienced in obtaining an MSDS, assistance is available from
ASM.
Contact your local ASM agent.
Cleaning Equipment
Disposal of Waste
Materials
All waste materials including fluids and contaminated materials must be dis-
posed of in accordance with national, federal or local legislation.
Description Part Number
IPA Impregnated Wipes 115806
Plastic Spatula (white) 173737
Plastic Spatula (green) 173788
Plastic Spatula (black) Antistatic 173825
ALL PURPOSE CLAMPING (APC)
MAINTENANCE SCHEDULE
Chapter Issue 1 Nov 16 All Purpose Clamping (APC) Manual 1.79
Weekly Maintenance
WARNING
HARMFUL SUBSTANCES. CLEANING WIPES AND CLEANING SOLUTIONS MAY
CONTAIN SUBSTANCES HAZARDOUS TO HEALTH. OBSERVE ALL
MANUFACTURERS’ HEALTH AND SAFETY GUIDELINES. ALWAYS WEAR
APPROVED PROTECTIVE CLOTHING WHEN CLEANING THE MACHINE.
WARNING
BOARD CLAMPS. EXTREME CARE MUST BE EXERCISED WHEN WORKING IN
THE TOOLING AREA OF THE MACHINE TO AVOID INJURY. THE FOILS ON THE
FRONT AND REAR BOARD CLAMPS ARE VERY SHARP.
MANDATORY
TOXIC CHEMICALS MAY BE PRESENT. SAFETY GLOVES MUST BE WORN.
MANDATORY
TOXIC CHEMICALS MAY BE PRESENT. EYE PROTECTION MUST BE WORN.
Preparation The machine must be isolated from electrical power and air pressure. Remove
the stencil if fitted.
General
APC System Tick
Clean the APC modules to ensure they are free from paste and debris (see following page).
Check there is no damage to the board clamp foils. If damaged, replace (see following page).
Summary/Remarks
Signed: Date:
ALL PURPOSE CLAMPING (APC)
MAINTENANCE SCHEDULE
1.80 All Purpose Clamping (APC) Manual Chapter Issue 1 Nov 16
Clean APC Modules Ensure the APC modules are free from paste and debris:
NOTE
Cleaning procedures are identical for both modules.
1. Wipe top plates and snug bar face, and ensure free from paste and debris.
2. Slide top plate rearwards, clean internal snug area and ensure free from
paste and debris.
Check Board Clamp
Foils For Wear/
Damage
Check board clamp foils for any signs of wear or damage (bent foils, impact
damage etc).
If worn or damaged, see Board Clamp Foil Replacement in the Replacement
Procedures section of this Chapter.
Tasks
1
Top Plate
Snug Bar Face
2
Snug Bar Internal Face