F5 SERVICE MAUNAL.pdf - 第183页
SIPLACE 80S-20/F4 Service Manual 6 PCB Handling Edition 01/96 6.5 Retainers and Co mpression Springs 6 - 27 6.5.2 Fitting the retainers and compressi on springs The reta iners an d compr ession spr ings shou ld be f itte…
6 PCB Handling SIPLACE 80S-20/F4 Service Manual
6.5 Retainers and Compression Springs Edition 01/96
6 - 26
Fig. 6.5.1 Removing the retainers and compression springs
Key to Fig. 6.5.1
1 Side panel, fixed side 2 Retainer
3 Comb guide 4 DU strips
5 Guide rail 6 Compression spring
7 Block 8 Rocking lever
9 Side panel, movable side
1
9
2
4 B
5 E
7
6
F
8 A
3 C
D
SIPLACE 80S-20/F4 Service Manual 6 PCB Handling
Edition 01/96 6.5 Retainers and Compression Springs
6 - 27
6.5.2 Fitting the retainers and compression springs
The retainers and compression springs should be fitted back in the reverse sequence of operations.
NOTE
Before fitting the compression springs check their length. When unloaded they should be 32 mm. If this is not
the case change the springs, always doing so in pairs for each side of the conveyor.
● Align the guide rails as described in Section 6.6, Page 6 - 29.
6.5.3 Function test
Under the Conveyor functions menu carry out a function test with the boards.
6 PCB Handling SIPLACE 80S-20/F4 Service Manual
6.5 Retainers and Compression Springs Edition 01/96
6 - 28