F5 SERVICE MAUNAL.pdf - 第465页
14 Pneumatic Cutter Service Manual SIPLACE 80S- 20/F4/F5 14.1 Pneumatic Cutter and Empty-Tape Duct Edition 04/98 14 - 7 14.1.6 Diagram for Adjustment of the One-way restrictors Fig. 14.1.3 Diagram for the A djustment of …
Service Manual SIPLACE 80S-20/F4/F5 14 Pneumatic Cutter
Edition 04/98 14.1 Pneumatic Cutter and Empty-Tape Duct
14 - 6
14.1.5 Diagram of Pneumatic System
Fig. 14.1.2 Diagram of Pneumatic System
Service Manual SIPLACE 80S-20/F4/F5 14 Pneumatic Cutter
Edition 04/98 14.1 Pneumatic Cutter and Empty-Tape Duct
14 - 8
14.1.7 Moving Stationary and Movable Blades 180 °
The cutter remains installed in the machine.
DANGER O O O
Comply
VWULFWO\
with the instructions in the DANGER text in Section 14.1.1.
NOTE
The movable blade has a
FXWWLQJHGJHRQERWKVLGHV
When one cutting edge becomes worn, the blade is
turned 180 °, inserted and continues to be used. When this is done, the stationary blade must
DOVR
be rotated
180 ° and installed.
When both edges have been used, i.e., are dull, proceed as described in Section 14.1.8.
14.1.7.1 Removing of the Blade
● Move the appropriate feeder changeover table out of the machine or (in case of F4/F5) dismantle the com-
ponent table and remove the component table..
● Loosen the bolts fastening the empty-tape duct (see Fig. 14.1.1 -> 9) and lift it out of the machine.
● Loosen the bolts fastening the cover plate (1 bolt each at holddown at left and right: see Fig. 14.1.4 -> 3
and Fig. 14.1.5 -> 9).
DANGER O O O
The cutting edges of the movable blade will be exposed during the subsequent dismantling of the cover blade.
There will be greater
ULVNRILQMXU\
● Lift off the cover plate (see Fig. 14.1.4 -> 2, 4).