F5 SERVICE MAUNAL.pdf - 第482页
Service Manual SIPLACE 80S-2 0/F4/F5 14 Pneumatic Cut ter Edition 04/98 14.1 Pneumatic Cutter and Empty-Tape Duct 14 - 24 q
14 Pneumatic Cutter Service Manual SIPLACE 80S-20/F4/F5
14.1 Pneumatic Cutter and Empty-Tape Duct Edition 04/98
14 - 23
● Remove the 4 rubber-metal vibration dampers from the retaining brackets (left and right) and install the
new dampers (item no.: see Section 14.1.2).
-> Always exchange
DOO
rubber-metal vibration dampers.
● Set the cutter back on the retaining brackets (with the rubber-metal vibration dampers)
DQGEROWLWWLJKW
(see Fig. 14.1.1 -> 5).
● Perform all the remaining steps as described in Section 14.1.15 under "Installing".
● Perform the appropriate “Final Steps.
14.1.17 Final Steps
● After disassembly work on the cutter in particular, check whether all of the parts of the cutter (e.g.,
including the cover plate over the movable blade: see Fig. 14.1.4 -> 3 and the cover over the controller
board: see Fig. 14.1.9 -> 14) are completely reassembled and all of the bolts are tightened.
● Where applicable, place the tape chute back into the machine from above.
● Move the changeover table back into the machine or (in the case of F4/F5) install the component table
again and set it up.
● Turn the compressed air back on at the main switch on the compressed air unit.
DANGER O O O
6WULFWO\
adhere to the instructions in the DANGER text in Section 14.1.1.
Greater risk of accident exists when working with the SITEST program.
● Load the SITEST program and actuate the cutting strokes (asee Operating Manual "SITEST Program").
● Exit the SITEST program, turn the key-operated switch to the normal position and lock up the key.
● Perform a
YLVXDOFKHFN
to make certain that all empty-tape ends are correctly guided downward in the
empty-tape duct. Start the placement sequence.
Service Manual SIPLACE 80S-20/F4/F5 14 Pneumatic Cutter
Edition 04/98 14.1 Pneumatic Cutter and Empty-Tape Duct
14 - 24
q
SIPLACE
Placement Systems
80S-20/F
4/
F
5
Service Manual
Edition 09/99
Order No. 00190716-06
SIPLACE
Placement Systems
80S-20/F
4
/F
5
Service Manual
Edition 09/99
Order No. 00190716-06