F5 SERVICE MAUNAL.pdf - 第250页
7 Components Table SIPLACE 80 S-20/F4 Service Manual 7.6 Empty Tape Cutting Unit and Empty Tape Channel Edition 03/97 7 - 48 7.6.13 Empty T ape Channel: Ch ecking and Replacing the Spring Bows If indiv idual tap es are n…
SIPLACE 80 S-20/F4 Service Manual 7 Components Table
Edition 03/97 7.6 Empty Tape Cutting Unit and Empty Tape Channel
7 - 47
Fig. 7.6.7 Checking the spring bows in the empty tape channel (guide plate, inner)
7 Components Table SIPLACE 80 S-20/F4 Service Manual
7.6 Empty Tape Cutting Unit and Empty Tape Channel Edition 03/97
7 - 48
7.6.13 Empty Tape Channel: Checking and Replacing the Spring Bows
If individual tapes are not being cut (tape jam in individual feeder modules), this may be due to the "guide
plate, inner" having bent spring bows.
● To check the spring bows proceed as shown in Fig. 7.6.8.
● If individual spring bows are bent, install a new "empty tape channel complete" or just replace the "guide
plate, inner" and slide the existing "guide plate, outer" back in.
● Adjust the new empty tape channel so that it is positioned symmetrically to the pressure rod (see below).
Fig. 7.6.8 Aligning the empty tape channel to the pressure rod when refitting
SIPLACE 80 S-20/F4 Service Manual 7 Components Table
Edition 03/97 7.6 Empty Tape Cutting Unit and Empty Tape Channel
7 - 49
7.6.14 Fitting and Aligning the Empty Tape Cutting Unit and Empty Tape
Channel
In the following cases align the empty tape channel symmetrically to the pressure rod:
– In the event of a fault, as when the outer tapes in each case (tracks 1/120) are not being cut correctly.
– When refitting the empty tape cutting unit and/or the empty tape channel.
Fig. 7.6.9 Aligning the empty tape channel to the pressure rod when refitting
● Reinstalling and adjusting the empty tape channel:
If it is only the empty tape channel which has been replaced, proceed as follows.
● If necessary, unscrew the mounting of the empty tape channel and align the empty tape channel sym-
metrically to the pressure rod of the cutting unit as shown in Fig. 7.6.9.
● Screw down the guide channel in this position.