SIPLACE D4-D4i 工程师手册_EN.pdf - 第109页
Service Work 4.3.2 Cutter PCB conveyor system Service Manual SIPLACE D4/D4i 109 4.4 4 . 4 P C B c o n v e y o r s y s t e m PCB conveyor system There are two types of PCB conveyor systems for the D/Di-se ries . 1. Modula…
Service Work
Component Handling 4.3.2 Cutter
108 Service Manual SIPLACE D4/D4i
► Calibrate the nozzle changer.
► Load the SITEST program and actuate the cutting strokes (see Operating Manual "SITEST Pro-
gram").
► If the nozzle changer was removed:
► Use the SITEST program to calculate the position of the nozzle changer.
► Exit the SITEST program.
► Perform a visual check to make certain that all empty-tape ends are correctly guided downward in
the empty-tape duct.
See also
4.3.2.4.1 Tightening Torques for Cutter Screws [ ➙ 83]
6.4.3 Check the gap between the empty-tape baffle, inside and the leading edge of the tape deflec-
tor. [ ➙ 223]
DANGER
► The SITEST program may only be started by personnel who have been trained in its use
by Siemens and are therefore authorized to do so.
► When the SITEST program is used, additional, higher risk of an accident exists aside from
the generally higher danger posed by the blades of the cutter.
Service Work
4.3.2 Cutter PCB conveyor system
Service Manual SIPLACE D4/D4i 109
4.4
4.4 PCB conveyor system
PCB conveyor system
There are two types of PCB conveyor systems for the D/Di-series.
1. Modular PCB conveyor system with automatic width adjustment unit
Modular conveyor, movable rail
WARNING
Nonobservance of these safety instructions may cause injury to personnel and damage to the
machine!
The service work described in this manual may only be performed by specially trained service
technicians, with appropriate qualifications and expertise.
► Please observe the safety instructions in the Operating Manual for all service work!
Service Work
PCB conveyor system 4.3.2 Cutter
110 Service Manual SIPLACE D4/D4i
Modular conveyor, fixed rail