4OM-1733-005w_F8.pdf - 第107页
4OM-1733 1-4-34 1403-005 4.7 Head Section 4.7.9 Head U/D Linear Guide (HL Axis) Cleaning and Oiling Cycle : Every 3 Months (Required Time : 5 minutes) Grease : DAPHNE EPONEX GREASE No.1 Head U/D Linear Guide (HL Axis) Fi…
4OM-1733
1-4-331403-005
4.7 Head Section
4.7.8 Head U/D Ball Screw (HL Axis) Cleaning and Oiling
Cycle : Every 3 Months (Required Time : 5 minutes)
Grease : DAPHNE EPONEX GREASE No.1
Head U/D Ball Screw (HL Axis)
Fig. 4A4-44-1
Procedure
(1) Wipe old grease out using a rag.
(2) Apply grease in the ball screw groove slightly using the syringe.
Note
Use No. 19 (brown) nozzle.
No.19
Fig. 4A4-44-2
(3) After lubrication, move the HL-axis up and down 25 mm ve times using the
manual axis operation to smooth the grease.
4OM-1733
1-4-341403-005
4.7 Head Section
4.7.9 Head U/D Linear Guide (HL Axis) Cleaning and Oiling
Cycle : Every 3 Months (Required Time : 5 minutes)
Grease : DAPHNE EPONEX GREASE No.1
Head U/D Linear Guide (HL Axis)
Fig. 4A4-44-3
Procedure
(1) Wipe old grease out using a rag.
(2) Apply grease in the linear guide groove slightly using the syringe.
Notice
Apply grease, taking care that the grease does not stick to the
sensor.
Note
(a) Use No. 19 (brown) nozzle.
(b) Grease should be applied every 3 months after the initial month.
No.19
Fig. 4A4-44-4
(3) After lubrication, move the HL-axis up and down 25 mm ve times using the
manual axis operation to smooth the grease.
4OM-1733
1-4-35
4.8 X/Y Beam Section
X-Axis Linear Guides (4 locations)
Every Day Inspection
Required Time: 1 minute
X-Axis Linear Guides (4 locations)
Every 3 Months Cleaning and Lubrication
(DAPHNE EPONEX GREASE No. 1)
Required Time: 5 minutes
Y-Axis Linear Guides (4 locations)
Every Day Inspection
Required Time: 1 minute
Y-Axis Linear Guides (4 locations)
Every 3 Months Cleaning and Lubrication
(DAPHNE EPONEX GREASE No. 1)
Required Time: 5 minutes
Fig. 4A4-45
1211-002
4.8 X/Y Beam Section