4OM-1733-005w_F8.pdf - 第99页

4OM-1733 1-4-26 4.7.1 Nozzle Up/Down Ball Screw (NL-axis) Cleaning and Oiling Cycle : Every 3 Months (Required Time : 10 minutes) Grease : DAPHNE EPONEX GREASE No.1 Nozzle U/D Ball Screw (NL Axis) Fig. 4A4-33 Procedure (…

4OM-1733

1-4-25

NOTICE

When the air-blowing is to be performed to the nozzle,

make sure to start it from the nozzle end section.

If the air-blowing is started from the clamp claw section, the

clamp claw might be damaged.

Vacuum Nozzle

Every 3 Months Inspection

Vacuum Nozzle

Every Week Cleaning

Air Blowing from the Tip

Clamp Claw

Nozzle Filter

Every Week Change

Fig. 4A4-32

Reference

Refer to "5. Vacuum Nozzle Cleaning Procedure" for the vacuum nozzle

cleaning.

1211-002

4.7 Head Section

4OM-1733

1-4-26

4.7.1 Nozzle Up/Down Ball Screw (NL-axis) Cleaning and Oiling

Cycle : Every 3 Months (Required Time : 10 minutes)

Grease : DAPHNE EPONEX GREASE No.1

Nozzle U/D Ball Screw

(NL Axis)

Fig. 4A4-33

Procedure

(1) Wipe old grease out using a rag.

(2) Apply grease in the ball screw groove slightly using the syringe.

Note

Use No. 19 (brown) nozzle.

No.19

Fig. 4A4-34

1211-002

4.7 Head Section

4OM-1733

1-4-27

4.7.2 Linear Measure (Light Projector and Receiver) Cleaning

Cycle : Every Day (Required Time : 5 minutes)

Linear Measure Sensor

(Light Emitter)

Linear Measure Sensor

(Light Receiver)

Fig. 4A4-35

Procedure

When any fat or oil is stuck to the line sensor, rub off the dirt using a cotton

applicator dipped in dehydrated ethanol.

1211-002

4.7 Head Section