4OM-1733-005w_F8.pdf - 第122页

4OM-1733 1-4-49 4.10.1 Linear Guide Cleaning and Oiling Cycle : Every 3 Months (Required Time : 5 minutes) Grease : DAPHNE EPONEX GREASE No.1 Linear Guide Fig. 4A4-60 Procedure (1) Wipe of f old grease with an oiled rag.…

4OM-1733

1-4-48

PCB Detection Sensor (8 locations)

Every Week Cleaning

Required Time: 2 minutes

The light receiving section is

located inside these sections

in the figure.

Fig. 4A4-59

1211-002

4.10 Conveyor Section

4OM-1733

1-4-49

4.10.1 Linear Guide Cleaning and Oiling

Cycle : Every 3 Months (Required Time : 5 minutes)

Grease : DAPHNE EPONEX GREASE No.1

Linear Guide

Fig. 4A4-60

Procedure

(1) Wipe off old grease with an oiled rag.

(2) Attach the H-type attachments to a hand grease gun and supply new grease

to the grease nipples with the hand grease gun.

Note

Use type H nozzle.

Type H

PT1/8

Fig. 4A4-61

Note

Perform the cleaning and oiling operations using the same procedure also in the

system where the Y510 mm Single Transfer Unit (Option) has been mounted.

1403-004

4.10 Conveyor Section

4OM-1733

1-4-50

4.10.2 Support Pin Detection Sensor Cleaning

Cycle : Every Week (Required Time : 1 minute)

Support Pin Detection Sensor

Fig. 4A4-62

Procedure

Clean the support pin detection sensors with a rag.

Note

Perform the cleaning operation using the same procedure also in the system

where the Y510 mm Single Transfer Unit (Option) has been mounted.

1403-004

4.10 Conveyor Section