4OM-1733-005w_F8.pdf - 第83页

4OM-1733 1-4-10 4.3 Component Recognition Camera Section NOTICE Donotputyourhandontotheducialmarkblock. Iftoomuchforceisgiventotheducialmarkblockit may become deformed. Fiducial Mark Block Componen…

4OM-1733

1-4-9

4.2.2 Filter Cleaning

Cycle : Every 3 Months (Required Time : 10 minutes)

Filter Case

Filter

Fig. 4A4-10

Procedure

(1) Remove four setscrews fastening the cover located at the lower area of the

front side of the machine and detach the cover.

(2) Rotate the lter case in Arrow Direction C to detach and then take out the

lter.

(3) Blow air to the lter for cleaning.

Note

When the vacuum pressure has dropped during the operation, replace the

lter with a new one.

(4) Attach the cover and tighten the setscrews.

Notice

If a clearance is left between the main machine and the cover, the

tape will pop out from the clearance during the operation, causing

the machine to breakdown or generate an error.

1211-002

4.2 Vacuum System

4OM-1733

1-4-10

4.3 Component Recognition Camera Section

NOTICE

Donotputyourhandontotheducialmarkblock.

Iftoomuchforceisgiventotheducialmarkblockit

may become deformed.

Fiducial Mark Block

Component Recognition Camera

(4 locations)

Every Day Cleaning

Required Time: 4 minutes

Fig. 4A4-11

Standard Condition

Condition where the Nozzle Stocker for Middle Size Odd Shaped Nozzle (Option),

and Rejected Component Box (Option) have been mounted onto the system

Component Storage Box

Every Day Cleaning

Required Time: 1 minute

Fiducial Marks (4 locations)

Every Week Cleaning

Required Time: 2 minutes

Fig. 4A4-12

Note

These options are selected together with the high-speed head SIGMA-F8

(HL) as a factory set when the system is delivered from the factor.

1403-005

4.3 Component Recognition Camera Section

4OM-1733

1-4-11

4.3.1 Component Recognition Camera Cleaning

Cycle : Every Day (Required Time : 4 minutes)

Fiducial Mark Block

Component Recognition

Camera (4 locations)

Fig. 4A4-13

Procedure

(1) Remove any dropped component, etc., using the vacuum tweezers.

(2) Wipe any dust off using the lens cleaner cloth.

Note

G -S047-01 Adhesive Cleaner (Part No: 226J2091) is also available as an option

Adhesive Cleaner

Fig. 4A4-14

Notice

Use a suction force such as a vacuum cleaner for the cleaning.

Do not blow air to any cleaning section with an air gun.

When air is blown, the dirt and dust inside the machine will disperse,

causing the recognition system and the machine to malfunction.

1403-005

4.3 Component Recognition Camera Section