4OM-1733-005w_F8.pdf - 第118页

4OM-1733 1-4-45 4.9.2 Ball Screw Cleaning and Oiling Cycle : Every 3 Months (Required Time : 10 minutes) Grease : DAPHNE EPONEX GREASE No.1 Ball Screw Fig. 4A4-57 Procedure (1) Wipe old grease out using a rag. (2) Apply …

4OM-1733

1-4-44

4.9.1 Backup Table Upper Surface Cleaning

Cycle : Every Week (Required Time : 2 minutes)

Backup Table Upper Surface

Fig. 4A4-56

Procedure

Remove foreign substances and unrequired components and suck dirt and dust

with a vacuum cleaner.

Note

Perform the cleaning operation using the same procedure also in the system

where the Y510mm Single Transfer Unit (Option) has been mounted.

1403-004

4.9 PCB Positioning Section

4OM-1733

1-4-45

4.9.2 Ball Screw Cleaning and Oiling

Cycle : Every 3 Months (Required Time : 10 minutes)

Grease : DAPHNE EPONEX GREASE No.1

Ball Screw

Fig. 4A4-57

Procedure

(1) Wipe old grease out using a rag.

(2) Apply new grease on the screw shaft using a syringe.

Note

Perform the cleaning and oiling operations using the same procedure also in the

system where the Y510mm Single Transfer Unit (Option) has been mounted.

1403-004

4.9 PCB Positioning Section

4OM-1733

1-4-461403-004

4.9 PCB Positioning Section

4.9.3 Ball Screw Spline Cleaning and Oiling

Cycle : Every 6 Months (Required Time : 10 minutes)

Grease : DAPHNE EPONEX GREASE No.1

Grease Nipple

Ball Screw Spline

(Under side of Backup Table)

Fig. 4A4-57-1 Y510 mm Single Transfer Unit (Option)

Note

This optional unit can be selected when the system is delivered from the factory.

Procedure

(1) Wipe out old great using a cloth.

Do not leave any ber on it.

(2) Attach the micro hose onto the hand grease gun and apply new grease from

the grease nipple.

Note

The nozzle to be used should be SPK-3C.

Fig. 4A4-57-2