ServiceInstruction_Vision XP.pdf - 第12页
Page 8 Vision XP+ V AC 2 M aintenance 2.2 Recomme ndations for the use of chemical clean- ing agents Operating Instructions V ersion 1.5 • Funnel • W a tering can Cleaner: • CF1 oven cleaner ( water based cleaner for nor…
Vision XP+ VAC Page 7
2 Maintenance
2.1 General Notes
Operating Instructions
Version 1.5
2 Maintenance
All of the tasks required for keeping the system in safe operating condition
are described in this chapter.
2.1 General Notes
Only original replacement parts and authorized accessories from
Rehm Thermal Systems GmbH may be used. The use of other parts impairs
system safety, and may void the manufacturer’s liability for damages result-
ing therefrom.
2.2 Recommendations for the use of chemical cleaning agents
Please use only alcohol-free, non-flammable or flame-retardant agents for
cleaning the soldering oven.
The following tools, consumable materials and auxiliary materials are re-
quired for the performance of maintenance work.
Tools:
• Standard tools such as hex keys and wrenches
• Ratchet with socket set
• Puller with M8 thread
• Plastic hammer
• Prying tool
• Putty knife
• Vacuum cleaner
• Brush
Note!
If maintenance / repair work is done by personnel without an appro-
priate training by Rehm, Rehm declines all claims under warranty.
Note!
Before closing the oven, it is essential to check that no cleaning agent con-
tainers (bottles, tins etc.) have been left in the oven chamber!
Page 8 Vision XP+ VAC
2 Maintenance
2.2 Recommendations for the use of chemical clean-
ing agents
Operating Instructions
Version 1.5
• Funnel
• Watering can
Cleaner:
• CF1 oven cleaner (water based cleaner for normal contamination)
• G 50 oven cleaner (water based cleaner for heavy contamination)
• Appropriate cleaning agent
• Rags
Lubricant
• Chain oil Addinol
• Lubricant
Vision XP+ VAC Page 9
2 Maintenance
2.2 Recommendations for the use of chemical clean-
ing agents
Operating Instructions
Version 1.5
Other supplies and materials
• Avia Antifrost C - antifreeze, (corrosion protection for internal coolant wa-
ter circuit)
• Granulate
• various filters
• Felt wheels
The points listed below must be executed before performing any of the tasks
described in these instructions.
1. Switch off the heaters and the conveyor.
2. Before performing any further work, wait until the shutdown routine has
been fully completed!
3. Set the operating mode software-switch to Service.
Attention!
Allow the system to cool down for at least 1 hour before working in the
heating chamber. The door at the front should be opened as well.