ServiceInstruction_Vision XP.pdf - 第62页

Page 58 Vision XP+ V AC 2 Maintenance 2.15 Conveyor System Operating Instructions V ersion 1.5 2.15.2 Chain oiler maintenance VXP+ Fig. 2-9 9 T ranspo rt chain oi ler (top) Fig. 2-1 00 Chain oiler - MU (bot tom) Consumab…

100%1 / 142
Vision XP+ VAC Page 57
2 Maintenance
2.15 Conveyor System
Operating Instructions
Version 1.5
2.15 Conveyor System
2.15.1 Chain Lubricator – Checking and Refilling the Tank
Fig. 2-98 Chain lubricating pumps with two
and one outlet
The chain lubricator is located on
the operator side behind the second
door on the right.
There are two chain lubricating
pumps in the VXP system, each
with one or two outlets.
Consumable materials, tools:
• Chain fluid
Procedure:
1. Fill to a level of about 1 cm be-
low the brim.
2. Inspect to make sure that the
hose connectors are securely
attached to the lubricator units.
Caution!
The chain lubricator should not be
allowed to run completely empty,
because if the pump runs dry dam-
age may result.
Page 58 Vision XP+ VAC
2 Maintenance
2.15 Conveyor System
Operating Instructions
Version 1.5
2.15.2 Chain oiler maintenance VXP+
Fig. 2-99 Transport chain oiler (top)
Fig. 2-100Chain oiler - MU (bottom)
Consumable materials, tools:
• Chain Fluid
Procedure:
1. Apply the chain oil to the trans-
port chains by droplets.
2. Check the chain oiler settings in
the controller if there is no chain
oil. Start the chain oiler manual-
ly and check if oil reaches the
oiling unit.
3. Also ensure that the outlet is not
blocked.
4. Pull the Festo hose from the an-
gle unit and blow through with
compressed air. Then plug
back the hose properly.
Vision XP+ VAC Page 59
2 Maintenance
2.15 Conveyor System
Operating Instructions
Version 1.5
2.15.3 Cleaning the Sensors
Fig. 2-101 Cleaning the Sensors
Consumable materials, tools:
• appropriate cleaning agent
• Rags
Procedure:
1. Carefully wipe the sensors with
appropriate cleaning agent and
a rag.
Caution!
Do not press the sensors too firmly,
and do not bend them. Do not use
any sharp objects for cleaning.
Note!
The sensors are to be cleaned only
with alcohol and solvent-free clean-
ing agent.