ServiceInstruction_Vision XP.pdf - 第9页
Vision XP+ V AC Page 5 1 Introductio n 1.3 Safety Prec autions Operating Instructions V ersion 1.5 • Always obse rve applicable safety an d accident preventi on regulations when carrying out servicing, set-u p and replac…
Page 4 Vision XP+ VAC
1 Introduction
1.3 Safety Precautions
Operating Instructions
Version 1.5
1.3 Safety Precautions
.
Danger!
Processes in the plant may generate toxic or flammable vapours.
Volatile, highly flammable substances may create explosive atmospheres
when mixing with ambient air in certain ratios.
Warning!
Aggressive chemical substances may irritate the respiratory tract and skin.
Wear suitable protective gloves and goggles as required.
Danger!
The plant operates on electrical power. When operating electrical equip-
ment, certain parts will necessarily be at high voltage.
Work on electrical equipment and the switchgear cabinet may only be car-
ried out by qualified technicians in cognisance of regulations and guidelines
applicable on site.
Isolate the plant from mains supply before working on electrical compo-
nents!
Switch off the master switch and secure against accidental switch-on by
means of a padlock.
Danger!
The supply leads to the master switch will remain live!
They are identified inside the switch cabinet by orange shrouded wiring.
Electric shock when touching live wiring.
Before carrying out work in this area, the supply leads must be isolated on
the operator side.
Warning!
Do not use the master switch to power off the machine. First switch the ma-
chine off from the operator console, and wait until it has shut down com-
pletely and all motors have stopped.
Electrical charges can still be stored in the system even after it is turned off
from the master switch.
Once you have switched off the system, wait at least six minutes before
touching live connectors or undoing connectors. Check to make sure that
the system is de-energised.
Vision XP+ VAC Page 5
1 Introduction
1.3 Safety Precautions
Operating Instructions
Version 1.5
• Always observe applicable safety and accident prevention regulations
when carrying out servicing, set-up and replacement work.
• Follow all safety instructions in this service guide, and the “Operational
safety” section in the previous operating manual.
• Always wear protective goggles when starting the open system in Service
mode.
• Always wear protective goggles and gloves when carrying out cleaning
work on the system.
• When cleaning agent accidentally enters an eye, watch it out immediately
with water.
• Do not eat or drink at the workplace.
• Do not smoke as flammable vapours may result.
Page 6 Vision XP+ VAC
1 Introduction
1.4 Protective Clothing
Operating Instructions
Version 1.5
1.4 Protective Clothing
Fig. 1-1 Protective clothing
Personnel must wear the protective clothing above when carrying out clean-
ing and maintenance work on the system.
Note!
The personal protective equipment must have a CE label confirming that
the manufacturer has fulfilled the requirements of EC directives and EN
standards in the production of the personal protective equipment.