HS50_advance_level 1_20200522_221201 (1).pdf - 第166页

06/2002 E dition Studen t Guide H S-50 Advance d I 5 DLM1 C&P H ead 74 5 5 5. 4.12 .5 Set ti ngs ➠ Close the protective cover . ➠ Check that you have removed all tools and equipment from inside the placem ent system.…

100%1 / 567
Student Guide HS-50 Advanced I 06/2002 Edition
5 DLM1 C&P Head
73
➠ Check that the plugs of the 40-pin ribbon cables between the intermediate distribution board
and head board are correctly assigned:
➠ Make sure that the cables are not damaged and that there is no strain on the connecting
cables.
➠ Refer to Fig. 5.4 - 29 and Table 5.4 - 5 for connecting the compressed air hoses.
5
Fig. 5.4 - 29 Connection diagram for the compressed air hoses on the collect&place head
Cable Head board Intermediate distribution board
00333491-W1 X14 X1
00333491-W2 X13 X2
Tab. 5.4 - 4 Plug-in connections for the flat ribbon cables on the head board
06/2002 Edition Student Guide HS-50 Advanced I
5 DLM1 C&P Head
74
5
5
5.4.12.5 Settings
➠ Close the protective cover.
➠ Check that you have removed all tools and equipment from inside the placement system.
➠ Start the placement system.
➠ Use the SITEST program to calibrate the collect&place head.
Fig. 5.4 - 30 Connection positions for vacuum generator on DLM1-12 head for machines HS50 and HS55
Compressed air hose no. Connection
1 Not connected
2 + 5 Via Y-shaped connecting piece to holding circuit (Y)
3 Placement circuit
4 Forced air unit
6 + 7 Holding circuit
Tab. 5.4 - 5 Connection diagram for the compressed air hoses on the collect&place head
Student Guide HS-50 Advanced I 06/2002 Edition
5 DLM1 C&P Head
75
5.4.13 Removal of DP station
5.4.13.1 Tools and equipment
– Set of DIN 911 Allen keys
– SITEST program
5.4.13.2 Parts
Turning station / DLM1, item no. 00341780-01 5
5.4.13.3 Dismantling the DP station
➠ Switch the placement system off and secure it to prevent switching on again as described in
section 5.4.1
, page - 32.
➠ Remove the plugs from sockets X12 and X18 on the head board.
5
Fig. 5.4 - 31 Plug-in connections of the turning station on the head board
➠ Push the collect&place head until it reaches the stopper on the deflection roller of the X-axis
toothed belt.
➠ Undo the M3x25 hexagon socket-head screw (see item 2 in Fig. 5.4 - 32) on the rear panel of
the back part.
➠ Carefully pull the turning station (item 1 in Fig. 5.4 - 32) back and remove.