HS50_advance_level 1_20200522_221201 (1).pdf - 第402页
S tud ent Guid e HS-50 A dvanced I E dition 06/2 002 1 1 P neumatic Cutt er and Empty- T ape Du ct 15 Fig. 11.5. 2 D iagr am of Fu ncti onal Sequ ence
Edition 06/2002 Student Guide HS-50 Advanced I
11 Pneumatic Cutter and Empty-Tape Duct
14
11.5 Diagrams of Pneumatic System and Functional
Sequence
Fig. 11.5.1 Diagram of Pneumatic System: Cutter per Conveyor Side
Student Guide HS-50 Advanced I Edition 06/2002
11 Pneumatic Cutter and Empty-Tape Duct
15
Fig. 11.5.2 Diagram of Functional Sequence
Edition 06/2002 Student Guide HS-50 Advanced I
11 Pneumatic Cutter and Empty-Tape Duct
16
11.6 Resolving Problems
DANGER
Strictly adhere to the instructions in the DANGER text in Section 11.1 ! 11
WARNING
Wear appropriate thick protective gloves whenever working near the blades / the tape deflector.
High risk of injury exists from stationary blade and movable blade and the tape deflector of the
cutter, even when the machine has been turned off.
Never reach into the pneumatic cutter from below or into the empty-tape duct from above, not even
to resolve a problem (e.g., when tape is jammed). 11
11.6.1 Exchanging the Pneumatic Cutter
WARNING
Wear appropriate thick protective gloves.
When removing the cutter, hold it only on the left and right, on the outside.
Never support the cutter on your body, e.g., on your knees or thighs.
Do not place your feet under the cutter.
You could injury yourself severely or at least damage your clothing.
Make certain that no one can injury themselves on the cutter after it has been dismantled. 11
11.6.1.1 Removing the Cutter
à Turn the machine and then the compessed air ON.
à Disconnect the movable component changeover table from the machine and move it out of the
machine.
à Turn the machine OFF, disconnect the machine from the mains and turn off the flow of com-
pressed air at the compressed air unit. Actuate the needle valve on the compressed air unit to
bleed the compressed air lines (see DANGER text in Section 11.1).