00198140-01_UM_JTF-ML_TX12_de_en.pdf - 第87页

Setting up and Commissioning 4.2.5 Converting the COT Insert Retrofit ting in the SIPLACE TX-Series JEDEC Tray Feeder (JTF-ML) 87 Connecting the compressed air hose CAUTION! Make sure that the m ach ine is switched off. …

Setting up and Commissioning

Retrofitting in the SIPLACE TX-Series 4.2.5 Converting the COT Insert

86 JEDEC Tray Feeder (JTF-ML)

Removing the NC holder

► Remove the reject bin (1).

► Remove the screws (3) fastening the two NC

holders (2) and remove the NC holders.

Removing the empty-tape duct assembly

► Remove the two screws (2) holding the empty-tape

duct assembly (1).

► Carefully lift the empty-tape duct out of the COT in-

sert.

Setting up and Commissioning

4.2.5 Converting the COT Insert Retrofitting in the SIPLACE TX-Series

JEDEC Tray Feeder (JTF-ML) 87

Connecting the compressed air hose

CAUTION!

Make sure that the machine is switched off.

At the bottom, on the traverse bar (1) of the COT insert,

you will find a 3-fold compressed air distributor (2). One

of the connections on the 3-fold distributor is closed with

a plug.

► Remove the plug.

► Connect the compressed air hose with the QSM-4

connector.

Fitting the holder

► Fit the holder (2), using the two screws ISO4762-

M6x14-A2-70 [03043125-xx] provided, to the trav-

erse bar (1).

When tightening the screws, press the holder up-

wards, against the edge (3).

Setting up and Commissioning

Retrofitting in the SIPLACE TX-Series 4.2.5 Converting the COT Insert

88 JEDEC Tray Feeder (JTF-ML)

Fitting the empty-tape duct and cover

► Fit the short empty-tape duct (1), using two ISO4762-

M6x14-A2-70 [03043125-xx] screws.

► Fit the cover (2) using two ISO4762-M6x14-A2-70

[03043125-xx] screws.

Removing the NC holder

Perform the following steps on the dismantled NC holder:

► Remove the screw (2) fastening the support (1) and

remove this.

► Remove the screw (3) fastening the nozzle station

and the reject bin holder (4) and remove this.

NOTICE!

The previously used nozzle station is no longer needed.

Fitting the NC holder

► Fit the two NC holders (2) , with two screws in each

case (1).

Do not fit the NC yet.