00198140-01_UM_JTF-ML_TX12_de_en.pdf - 第88页

Setting up and Commissioning Retrofitting in the SIPLACE TX-Series 4.2.5 Converting the COT Insert 88 JEDEC Tray Feeder (JTF-ML) Fitting the e mpty-tape d uct and cov er ► Fit the short e mpty-tape duct (1) , using two I…

Setting up and Commissioning

4.2.5 Converting the COT Insert Retrofitting in the SIPLACE TX-Series

JEDEC Tray Feeder (JTF-ML) 87

Connecting the compressed air hose

CAUTION!

Make sure that the machine is switched off.

At the bottom, on the traverse bar (1) of the COT insert,

you will find a 3-fold compressed air distributor (2). One

of the connections on the 3-fold distributor is closed with

a plug.

► Remove the plug.

► Connect the compressed air hose with the QSM-4

connector.

Fitting the holder

► Fit the holder (2), using the two screws ISO4762-

M6x14-A2-70 [03043125-xx] provided, to the trav-

erse bar (1).

When tightening the screws, press the holder up-

wards, against the edge (3).

Setting up and Commissioning

Retrofitting in the SIPLACE TX-Series 4.2.5 Converting the COT Insert

88 JEDEC Tray Feeder (JTF-ML)

Fitting the empty-tape duct and cover

► Fit the short empty-tape duct (1), using two ISO4762-

M6x14-A2-70 [03043125-xx] screws.

► Fit the cover (2) using two ISO4762-M6x14-A2-70

[03043125-xx] screws.

Removing the NC holder

Perform the following steps on the dismantled NC holder:

► Remove the screw (2) fastening the support (1) and

remove this.

► Remove the screw (3) fastening the nozzle station

and the reject bin holder (4) and remove this.

NOTICE!

The previously used nozzle station is no longer needed.

Fitting the NC holder

► Fit the two NC holders (2) , with two screws in each

case (1).

Do not fit the NC yet.

Setting up and Commissioning

4.2.6 Converting the Machine Protective Features Retrofitting in the SIPLACE TX-Series

JEDEC Tray Feeder (JTF-ML) 89

4.2.6

4.2.6 Converting the Machine Protective Features

Converting the Machine Protective Features

Removing the hand guard

1. Top rail with top hand guard below it

2. Bottom hand guard

► For removal of the following parts, read the relevant

section in the Assembly Instructions "Input and Out-

put Conveyor Extension SIPLACE TX"

[00198141-xx]

Removing the bottom rail

► Remove the bottom rail (1).

Removing the corner cover

Remove the corner cover (1). Proceed as follows:

► Remove the screws (2) on the outer side.

► Remove the screw (3) on the inner side.

Hold the corner cover firmly while doing this, so that

it does not accidentally fall down.

► Loosen the connector (4) and place the corner cover

to one side.