4M184002w_F8S.pdf - 第99页
4OM-1840 1-4-24 1604-001 Nozzle Change Cam Face (Upper Side) Every 3 Months Cleaning and Lubrication (DAPHNE GREASE MP No. 1) Required Time: 5 minutes Center Spline Every 3 Months Lubrication (DAPHNE GREASE MP No. 1) Req…
4OM-1840
1-4-231604-001
4.7 Head Section
Diffusion Plate
Every Month Cleaning
Required Time: 2 minutes
Linear Measure Sensors
(Light Emitter and Receiver)
Every Day Cleaning
Required Time: 5 minutes
Nozzle U/D Ball Screw (NL Axis)
Every 3 Months Cleaning and Lubrication
(DAPHNE GREASE MP No. 1)
Required Time: 5 minutes
Head U/D Ball Screw
(high-speed multi-purpose head)
Every 3 Months Cleaning and Lubrication
(DAPHNE GREASE MP No. 1)
Required Time: 5 minutes
Head U/D Linear Guide (high-speed multi-purpose head)
Every 3 Months Cleaning and Lubrication
(DAPHNE GREASE MP No. 1)
Required Time: 5 minutes
Fig. 4A4-30
4.7 Head Section
4OM-1840
1-4-241604-001
Nozzle Change Cam Face (Upper Side)
Every 3 Months Cleaning and Lubrication
(DAPHNE GREASE MP No. 1)
Required Time: 5 minutes
Center Spline
Every 3 Months Lubrication
(DAPHNE GREASE MP No. 1)
Required Time: 4 minutes
Cam Followers
Every 3 Months Cleaning and Lubrication
(DAPHNE GREASE MP No. 1)
Required Time: 5 minutes
Filter holder O-ring (15 locations x 2 pcs)
Filter
O-ring
Vacuum Filters (15 locations)
Every 3 Months Change
Required Time: 30 minutes
Pull up vacuum filter holder with the filter attachment/
detachment jig. Replace 2 vacuum filters as shown in
the figure below.
Note
Use commercially available tweezers
for filter replacement.
When replacing filter / Lubrication /
Required time: 30 minutes per head
(DAPHNE GREASE MP No. 1)
Apply grease to the filter holder O-rings.
(2 locations above)
Fig. 4A4-31A
4.7 Head Section
4OM-1840
1-4-251604-001
NOTICE
When the air-blowing is to be performed to the nozzle,
make sure to start it from the nozzle end section.
If the air-blowing is started from the clamp claw section, the
clamp claw might be damaged.
Vacuum Nozzle
Every 3 Months Inspection
Vacuum Nozzle
Every Week Cleaning
Air Blowing from the Tip
Clamp Claw
Nozzle Filter
Every Week Change
Fig. 4A4-32
Reference
Refer to "5. Vacuum Nozzle Cleaning Procedure" for the vacuum nozzle
cleaning.
4.7 Head Section