00191025-01.pdf - 第589页
19 Error Messages S IPLACE 80S/F/G User’s Manual Edition 12/96 from Software Version S R.009.xx 19 - 2
SIPLACE 80S/F/G User’s Manual 19 Error Messages
Edition 12/96 from Software Version SR.009.xx
19 - 1
19 Error Messages
NOTE
Shortcuts used in the error messages displayed on the screen.
AKT = Update task of the aktuell.ma
BL = PCB barcode reader
BO = User interface
COMP = Component
COPLAN = Coplanarity module
DP = Data processing
EH = Error handler
GK = General coordinator
GU = Glueing unit
KLKONF = Glueing configuration
LR = Line computer
LRR = Line computer receive task
LRS = Line computer transmit task
MA = Machine
MC = Machine controller
MK = Fiducial
NF = Refill function
OPT = Optimization of glueing
PCB = Printed circuit board
PF = Package form
RS = Set-up
SC = Station computer
SF = Single functions
SR = Station computer
SV = Supervisor on machine controller
TA = Test output
VS or VIS = Vision system
WPC = Wafflepack changer
19 Error Messages SIPLACE 80S/F/G User’s Manual
Edition 12/96 from Software Version SR.009.xx
19 - 2
SIPLACE 80S/F/G User’s Manual 19 Error Messages
Edition 12/96 from Software Version SR.009.xx 19.1 Error Messages
19 - 3
19.1 Error Messages
1 Arm for turning station 1 does not swivel in
CAUSE
●
Component jammed between pinion and gearwheel; proximity switch incorrectly aligned
in hole; swivel-in mechanism stiff; motor defective; bero defective.
REMEDY
●
Remove component; adjust sensing distance; carry out maintenance; replace motor.
2 Arm for turning station 1 does not swivel out
CAUSE
●
Sensing distance incorrect; proximity switch defective; for further faults see fault no. 1.
REMEDY
●
Adjust sensing distance; for further remedial measures see fault no. 1.
3 D1 axis does not reach setpoint position
CAUSE
●
Greasy; motor with tacho defective; rotational movement of the sleeve in the segment stiff.
REMEDY
●
Clean friction wheel; replace motor with tacho and belt wheel and check axis calibration; replace
segment.
6 Arm for turning station 2 does not swivel in
CAUSE
●
Component jammed between pinion and gearwheel; proximity switch incorrectly aligned
in hole; swivel-in mechanism stiff; motor defective.
REMEDY
●
Remove component; adjust sensing distance; carry out maintenance; replace motor.
7 Arm for turning station 2 does not swivel out
CAUSE
●
Sensing distance incorrect; proximity switch defective; for further faults see fault no. 6.
REMEDY
●
Adjust sensing distance; for further remedial measures see fault no. 6.
8 D2 axis does not reach setpoint position
CAUSE
●
O-ring drive belt greasy; motor with tacho defective; rotational movement of the sleeve in the seg-
ment stiff.
REMEDY
●
Clean O-ring and friction wheel; replace motor with tacho and belt wheel and check axis calibration;
replace segment.