00198382-03_UM_SIPLACE-CA4-V2_EN.pdf - 第149页
Instruction manual SIPLACE CA4 V2 4 Setting up and commissioning From software version 713.0 Ed ition 12/2019 4.1 Delivery configur ation and transportation of placement ma chines 149 4 4 Fig. 4.1 - 3 Contact surfaces - …
4 Setting up and commissioning Instruction manual SIPLACE CA4 V2
4.1 Delivery configuration and transportation of placement machines From software version 713.0 Edition 12/2019
148
4.1.5.2 Means of conveyor
Use a fork-lift truck with the following specification to carry the placement machine:
4.1.5.3 Fork-lift attachment points on the placement machine
The diagram 4.1 - 3, page 149 shows the fork-lift attachment points on the placement machine for
lifting the placement machine off the pallet or transporting it without the pallet.
4
4
Please note the following points before you raise the placement machine in order to avoid irre-
versible damage to the placement machine:
4
4
Fork length Min. 1800 mm
Lifting power Min. 6,000 kg
Distance between forks with the forks running parallel
to the direction of PCB conveyor
Approx. 420 mm
PLEASE NOTE
Avoiding damage to the placement machine
When transporting the placement machine over longer distances, always use a pal-
let and fork lift.
WARNING
Aligning the forks
– The forks must be aligned parallel to the PCB conveyor.
– The forks must be aligned parallel to the placement machine.
WARNING
Risk of damage due to excessive fork spacing!
Increased fork spacing, which means that the placement machine is raised at points out-
side its contact surface, can lead to deformation of the placement machine frame and
cause damage to cables and lines.
The forks may only be opened to a degree which ensures that they are still within the
contact area of the machine underside (see fig. 4.1 - 3
, page 149).
Instruction manual SIPLACE CA4 V2 4 Setting up and commissioning
From software version 713.0 Edition 12/2019 4.1 Delivery configuration and transportation of placement machines
149
4
4
Fig. 4.1 - 3 Contact surfaces - forks parallel to the direction of PCB conveyor
(1) Contact surface for fork lift truck forks
4
4
WARNING
Risk of damage due to one-sided loading!
One-sided loading of the machine feet e.g. from tilting the machine, can lead to deforma-
tion of the machine feet fixtures.
Make sure that the forks are evenly loaded when you lift the placement machine.
Use a firm support layer between the forks and the placement machine.
Enlist the help of a second person to watch while you lift the placement machine and
make sure that the placement machine does not tip over to one side.
(1)
4 Setting up and commissioning Instruction manual SIPLACE CA4 V2
4.1 Delivery configuration and transportation of placement machines From software version 713.0 Edition 12/2019
150
4.1.5.4 Points that MUST be noted when transporting the machine
4
4
WARNING
Risk of damaging the machine feet!
The thread for the machine feet in the machine frame could be damaged by being
dragged along the floor or from impact.
When you are transporting the machine, make sure that all the feet are clear of the
floor.
WARNING
Risk of damaging the exhaust air duct for the vacuum pump!
Vacuum pumps can be fitted in placement area 1. The exhaust air duct is fitted under the
machine base. This exhaust air duct could be damaged during transportation with the
fork-lift.
Dismantle the exhaust air duct before you transport the placement machine with the
fork-lift.